Want this question answered?
How do I replace the rear wiper motor or just remove the rear panel on the back window to see if my rear wiper motor is unplugged on my 2007 Subaru Outback? Thanks!
The wiper control module is located inside the wiper motor assembly.
on the motor.
repair horn
The 2007 Mercedes-Benz c280 is not listed in the aftermarket references which usually indicates that they are special M-B wiper blades and wiper arm attachments. Since you have to go to the dealer anyway for wiper blades, ask them for the instructions too.
Check pp. 375-377 in your owners manual.....
Since rear wiper blades undergo substantial abuse - especially in icy/snowy locations - and most vehicle owners do not replace the rear wiper very often, I highly recommend replacing the entire wiper blade assembly (blade and frame) vs. (rubber wiper refill blade). It is only a few dollars difference.Be sure you get the correct-fitting replacement wiper blade. The 2001-2007 Chrysler Town & Country Van takes a fairly standard 16" rear wiper blade and installs similar to the front wiper blades.
The 2007 Acura MDX has the common hook-end wiper arm attachments. See related link below for video. Essentially lift the wiper arm away from the glass, look for a tab or button where the wiper blade is inserted into the arm hook. Press, and pull wiper out of hook. Sometimes you have to rotate and flex the wiper blade a little bit to make enough clearance.
All 2007 Toyota Camrys take the same 24" drivers and 20" passenger side wiper blades. See sources and related links below for more information and for installation videos.
Pop off the cap over the base of the wiper arm. Undo the nut .... replace arm. 10 minutes. If you order the new style wiper arm kit for 2007 and up it works way better! www.trailvoy.com Trailblazer enthusiasts forum run by true enthusiasts!
Yes, it has happened to me with my 2007 Ford Expedition. If the wiper is siezed in a position other than the normally off position, the motor will continue to strain to return to the off position. If this happens to you, make sure the rear wiper is turned off, then open the glass in the rear liftgate. This will disengage the motor from the wiper, and the motor should rotate counterclockwise to the off position. If the rear wiper is not too siezed, you should be able to manually move the wiper back to its off position before closing the rear glass. This will align the wiper drive pin on the inside of the glass with the drive slot in the motor. These need to be aligned to be able to close the glass. The faulty wiper arm assembly will likely need replacing.
5w20 for the 3.5L V6. 5w30 for the 2.2L 4cyl. 5 quarts in each.