Do not remove anything from the interior of the trunk, the only thing you have to do is pry out the light assembly, as it is only held in place by prongs. I found that a flat head screw driver (with a towel wraped around it) would get the upper and outer portion started so it can be pulled the rest of the way by hand. You will find that there is a spot for two 3057K bulbs. Warning removing the assembly to fast or with to much force can damage it, so use consistent force while prying it out.
3rd brake light or rear brake lights?
From inside the trunk.
The main problem might just be you mate.
show please how change plate light on an 2007 nissan sentra
The third brake light on a 2007 Toyota Avalon is replaced by first removing the rear, retaining screws. The wiring harness can then be disconnect and the light bulb removed.
How to reset the tire pressure light on a 2007 Nissan Sentra?
2007 Nissan Sentra brake light bulb replacement: Purchase the correct replacement brake light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement brake light bulb information. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for brake light bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
The brake light bulb on a 2007 Cadillac CTS can be replaced by opening the truck, removing the rear cover, and disconnecting the wiring harness. The bulb can then be twisted, removed, and a new bulb put in its place.
You can find the 2007 Nissan brake light fuse in the fuse box. The brake light fuse will be in the second column, third from the top.
how to change brake light switch in a 2007 chevy colorado
The way that you change a high mount brake light on a 2007 Taurus is by first prying the light assembly from the housing. You then push rearward to remove it from the retaining clips. Next, life the light assembly from the shelf and disconnect the assembly wiring. Replace the light assembly and reverse directions to put the light housing back where it goes.
You can't. It's electronic.. not battery operated.