0
What else can I help you with?
What type of battery does an 89 Acura Legend need?
Any auto parts store can help you with that.
Where is the radiator fan switch on a 89 Acura Legend?
The 1989 Acura Legend radiator fan switch can be found on the inside of the quarter panel. You can find the switch on the drivers side quarter panel.
I Need Wiring diagram for 89 Acura Legend?
Haynes Manuals Contain Wiring Diagrams in the back of the book.
Where is the fuel injection relay on 89 Acura Legend coupe?
The 1989 Acura Legend fuel injection relay switch can be found in the fuse box. The fuel injection relay switch will be in the third column, third from the top.
Heater wiring diagram 89 Acura Legend?
A heater wiring diagram can be found inside a 1989 Acura Legend workshop manual. The manuals will also have troubleshooting procedures detailing how to solve common problems with the vehicle.
Where is the blower motor for the heating system on a 89 legend coupe?
i had a 1990 acura legend my blower motor was located under the passenger side dash board
How is the transmission shift cable removed on the 89 Acura Legend?
The 1989 Acura Legend transmission shift cable is held in place with swivel nuts. Loosen the swivel nuts on each end of the cable. The transmission shift cable will come out.
How much mpg and hp does air intake improve on a 89 acura legend?
you will get 50 mpg more and at least 200 more horsepower
Where is condensor fan relay located on 89 Acura Legend 2700?
It is near the battery underneath the fuse box. It is necessary to remove the battery and fuse box to access it.
How do you replace timing belt on an 89 Mitsubishi truck?
factory timing alignment marks for mitsibushi L 200 diesel
Do you have to remove the crankshaft pulley to replace the balancer pulley belt on a 89 Mitsubishi mighty max 2.0-4-cylinder?
yes
How do you replace the fan belt in 89 Ford Laser KE engine build 86?
To replace the fan belt in an '89 Ford Laser KE with an '86 engine, start by ensuring the engine is off and cool. Loosen the tensioner bolt or the adjuster bolt on the alternator to release tension on the belt. Remove the old belt, and then route the new belt according to the belt diagram, ensuring it fits properly over the pulleys. Finally, re-tension the belt by adjusting the alternator or tensioner and tighten all bolts before starting the engine.
