Follow the + battery cable -jump the small terminal and the wire to the starter (Make sure in neutral) Starter should operate
== acura speed sensor }
The 1991 Acura Legend starter is located on the right hand side of the engine, near the front, at the bottom. You can follow the positive battery cable from the battery to the starter.
1. If it's a cable type from the speedo to the gearbox, the inner cable may need lubrication
In order to replace a clutch on 1989 Acura Legend, you would have to remove the old one. You will do this by removing the jam nut that holds the pedal and disconnecting it from the throttle cable and replace it with a new one.Ê
The way to replace the thermostat on a 91 Acura Legend Coupe is to drain the radiator and remove the throttle and cable box. Remove the top of the radiator hose and the bolts. The thermostat will be inside.
it will fit but you need to convert it to a cable clutch because the 98's are hydraulic
No, 90-93 was cable operated, 94-up was hydraulic.
It is mechanical, 2 piece cable, jack up car turn wheel left and look on drivers side and you will see cable.
Postive battery cable should connect to the starter relay (solenoid)
To replace the starter in a 1989 Acura Legend you must first disconnect the negative cable on the battery. Disconnect the starter motor making sure you label each of the wires as they are removed. Remove the bolts which hold the starter to the engine and slide out the starter. Position the new starter to the engine. Torque the mounting bolts using 32 pounds of foot pressure per bolt. Connect the wires to the starter using the labels as a guide. Reconnect the battery cable and check the starter operation.
The gears in your transmission may be sticking or worn out. This would cause your transmission to not be able to shift.