It is mechanical, 2 piece cable, jack up car turn wheel left and look on drivers side and you will see cable.
Manifold absolute pressure sensor, being hondas run of calculations to adjust fuel to air ratio (called speed density) they require this to calculate amount of fuel to use. This is on top of the manifold dependant upon year b18 head, Da's had sensors located on firewall. B20's have the exact same head cast and cams as a b18b head. unless your refering to a vtec head there is no difference.
No, but it is believed that the Wal-mart is. The supposed story is that a young girl was murdered behind the Wal-mart, when it still was a Farmer Jack in the late 90's. The legend also states that the girl was stuffed into a shopping cart, and left to die, from her stab wounds. http://theshadowlands.net/places/michigan.htm Part of the legend is on the shadow lands haunted places index. Have look, you'd be surprised of some of the indexed places.
-90° to +90°
If you want to do it yourself procure the Haynes Manual for your unit. Part number 24046 '90-94.: There may be a couple of sensors, the procedure below is for the 24x sensor if fitted. remove the drive belt. raise the car and support on jackstands remove the crankshaft pulley remove the bolt and the sensor wiring harness bracket. Note well the routing of the wiring as you must replace it as installed at the factory. remove the sensor mounting bolts and pull the wiring harness. reverse the procedure to install. After disturbing the seensor the crankshaft variation relearn procedure may be required. If the engine MIL light illuminates take it to a dealer and get them to reset the system for you. To replace the 7x sensor, disconnect the wire, remove the bolt holding the sensor in th eblock and withdraw the sensor. make sure you replace the O-ring after lubing it with engine oil.
50 to 70
I am in the process of replacing the speed sensor in my 90 prelude. It is located on the transmission. with a small cable with a plug on the end of it. Looking at it from the passenger side . you can see a picture of it on eBay.. just type in 1990 Honda speed sensor.. there are several...
It would be your ignition lock not cathing and needs to be replaced. I have 90 acura legend L. Problem is bad ignition switch. They are about $70 at autozone.
The speed sensor on a 90 lumina 3.1 should be on the drivers side top of the tranny, below the steering rod. Sould be a screw in sensor with wires attached.
To the left of the clock (on a Legend L series) is a little flip down panel. This covers the Hour and minute setting buttons. Simply press and hold the buttons down, and the clock time will change.
More than likely there is a grounded wire that would cause this. There may also be some blown fuses as well.
The speed sensor is on the right hand side (while facing the car from the front). It is below and behind the air intake tube on the back top of the transmission. They run 60-90 bucks for a replacement.
It would be helful to know where the oil dipstick is located, where to put engine oil into the engine at, what type of oil is required, and how to accomplish that task.
General VSS answerThis is for 90's integras & up but it will give you a good understanding on the general flaws in the Integras. goto http://techauto.awardspace.com/vss.HTMLthere are other good links there about the main relay and other things.
Yes, It will fit a 90-93
i just came across the same thing within the last week and it wasent a sensor its a cable drivin speedo...if that helps any
With a screwdriver.
same as for a 90'How_do_you_replace_the_alternator_on_a_1990_Acura_Integra