push the tensioner back with a 14mm, take off the belt, take off the pulley assembly
How to replace fog light bulb for acura rl 2002
can you cut the rotors on a 2002 acura
it is self adjusting .
A ratchet isÊneeded to loosen the serpentine belt tension pulley on a 2002 Jeep Wrangler V6. It will require a 1/2 inch ratchet.
put your pp in the pistons
75000 miles
You would typically use a serpentine belt tool or a breaker bar with the appropriate socket to loosen the tension pulley on a 2002 Cavalier. These tools help you apply enough force to release tension on the pulley so you can easily remove or install the serpentine belt.
You should be able to find a shop manual at your local library with the right info...make copies as they are usually only in the REFERENCE section....good luck:)
usally' u put a 15mm or 5/8" wrench on the nut in the middle of the pulley & move the SPRING loaded Pully.IF U aren't sure wich Pulley-WATCH witch pulley Vibrates when the engine is idleing-then turn OFF the engine & replace the Belt.
Put you car on jack stands, remove the right wheel. Loosen the tension pulley for the accessory belt (AC, alternator). Remove the belt. Loosen the tension pulley for the power steering, remove the belt. Install a new belt, and set proper tension. If you do not have a tool to measure tension, use rule of thumb. When the belt is under proper tension you should be able to twist only 3/4 of full twist. Do the same for the accessory belt.
You could do what I did, wait for the tension pulley to fall off the van...
Regardless of what type of vehicle you have, it is extremely difficult to replace a serpentine belt w/o a serpentine un-tension-er tool. This is a thin, long handle with a socket on the end that sticks out at 90 degrees of the handle. The socket slips onto the bolt-head of the tension-er pulley. Once the serpentine belt is threaded around all the other pulleys you put the un-tension-er tool on the tension-er pulley bolt and pull (or push) to achieve slack in the serpentine belt and slip it on the tension-er pulley.