0
What else can I help you with?
How do you replace a belt tension pulley of a 2002 Acura RSX?
push the tensioner back with a 14mm, take off the belt, take off the pulley assembly
How do you adjust the tension pulley on a 2002 Oldsmobile alero?
it is self adjusting .
What tool do you use to loosen the serpentine belt tension pulley on 2002 jeep wrangler v6?
A ratchet isÊneeded to loosen the serpentine belt tension pulley on a 2002 Jeep Wrangler V6. It will require a 1/2 inch ratchet.
How do you tighten tension pulley for 2002 Pontiac grand am 2.2L 4cy?
put your pp in the pistons
How do you replace tensioner pulley on an 02' Audi a6 3.0?
To replace the tensioner pulley on a 2002 Audi A6 3.0, first, disconnect the negative battery terminal for safety. Then, use a wrench to relieve the tension on the serpentine belt by rotating the tensioner pulley counterclockwise, allowing you to remove the belt. Next, unbolt the old tensioner pulley from its bracket and install the new pulley, ensuring it is secure. Finally, reattach the serpentine belt and reconnect the battery terminal.
Tools Needed to replace front brakes 2002 Ford Focus?
Tools needed to replace front brakes 2002 Ford Focus?
What kind of tool do you use to loosen tension pulley on a 2002 cavalier?
You would typically use a serpentine belt tool or a breaker bar with the appropriate socket to loosen the tension pulley on a 2002 Cavalier. These tools help you apply enough force to release tension on the pulley so you can easily remove or install the serpentine belt.
How do you release belt tension on a 2002 Dodge Ram?
usally' u put a 15mm or 5/8" wrench on the nut in the middle of the pulley & move the SPRING loaded Pully.IF U aren't sure wich Pulley-WATCH witch pulley Vibrates when the engine is idleing-then turn OFF the engine & replace the Belt.
How much should it cost to replace a vacuum tube on a Ford Focus 2002?
It will cost you about $743.00 to replace a vacuum tube on a Ford Focus 2002.
Replace belts on 2002 Mitsubishi eclipse?
Put you car on jack stands, remove the right wheel. Loosen the tension pulley for the accessory belt (AC, alternator). Remove the belt. Loosen the tension pulley for the power steering, remove the belt. Install a new belt, and set proper tension. If you do not have a tool to measure tension, use rule of thumb. When the belt is under proper tension you should be able to twist only 3/4 of full twist. Do the same for the accessory belt.
How do you loosen the serpentine belt on a 2002 Kia Sedona?
You could do what I did, wait for the tension pulley to fall off the van...
How do you get 2002 Toyota rav 4 serpentine belt on?
Regardless of what type of vehicle you have, it is extremely difficult to replace a serpentine belt w/o a serpentine un-tension-er tool. This is a thin, long handle with a socket on the end that sticks out at 90 degrees of the handle. The socket slips onto the bolt-head of the tension-er pulley. Once the serpentine belt is threaded around all the other pulleys you put the un-tension-er tool on the tension-er pulley bolt and pull (or push) to achieve slack in the serpentine belt and slip it on the tension-er pulley.
