Want this question answered?
How to change light blub in console on a Ford F150.
The nylon bushing at the bottom of the shifter is worn out. remove console. put shifter in the neutral position, unbolt shifter from transmission. replace bushing, then reinstall. good luck...
The park brake on my 2004 LS is in the center console below the shifter and is an electronic lever.
how to replace the light bulb on the gear shift on 2004 tracker
You will need to remove the center console cover. The lightbulb will be attached to the inside of the center console. Push the lightbulb in and turn at the same time to remove it. Reverse the process to install the new lightbulb.
Any "same year" Ford Expedition seat will fit. I just replaced the center console with a 2004 Expedition seat.
Are you referring to the knob on the shifter or the entire stick. It will help if you can tell us more about what's goin' on. FriPilot
shifter rod gear linkage
get a small screwdriver and there is a little pin in there that u pull out half way then it slides right off ..looks kinna like a staple ..
I have a 2004 Malibu and trying to remove the radio/defrost control console
I have a 2004 blazer and my manual shifter is removed by turning the hex nut just below the actual shifter clockwise. This may sound counter-intuitive as that is the direction to tighten but this spins the nut away from the shifter so the shifter is free to spin (counter-clockwise). So.... 1. Push boot around shifter down toward floorboard to expose shaft/nut coming out of tranny/gearbox 2. Turn nut clockwise to get away from shifter ( i used a small crescent ) i used a combo of 1st gear and reverse to get the right angles to fit wrench in. 3. Turn by hand the shifter (counter-clockwise) to remove. Or use pipe wrench with cloth around shifter to start the motion if stuck. Use a thick cloth to not scratch paint. 4. Nut and shifter are both free now. 5. This is also how you adjust the height of your shifter if you wish. Hope this helps
Check to see if Brake lamps work when brake pedal is pressed. If not gear shifter is locked for safety so replace fuse or repair brake lamp switch.