0
There is no cam sensor on a 90 3.1. Only a crank sensor.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Where is cam position sensor located on 1993 Chevy lumina?
Assuming that it is a 3.1 V6, as most of them are, there is no cam sensor. Only a crankshaft sensor. It is located behind the harmonic balancer. To replace it the balancer has to be removed.
How do you replace a cam shaft sensor and where is it located on a 1990 Pontiac Bonneville?
The cam shaft sensor is located behind the water pump pulley. One bolt that holds it in place.
Where is the cam sensor on a 1996 Chevy Lumina?
under neath the power stearing pump.
Where is the camshaft sensor on 1993 Chevy lumina euro?
There is no cam sensor on a 93 3.1. Just a crankshaft sensor....which is located behind the harmonic balancer. WRONG! it does in Fact have a cam position sensor! its underneath the intake plenum!
Where is cam sensor on 1992 lumina apv 3.8?
The cam sensor is mounted into the front timing cover just behind or near the water pump. Note that failure of the cam sensor to work properly is usually not cause by a faulty cam sensor but more commonly a failed permanent magnet located in the cam drive gear.
How do you fix the camshaft position sensor?
You locate cam-sensor check for loose or broken wires ,if this doesn't work replace cam-sensor.
Where is the cam sensor for a 2000 Chrysler cirrus 2.5 engine?
It is inside the distributor. You have to replace the distributor to service the cam sensor.
Do you need to replace cam sensor after replacing the crank sensor?
if you have a code w/ cam to crank reference then yes. if only a crank sensor issue the no
Where is the crank position sensor on 1990 Dodge Dakota 3.9L?
No crank sensor on a 1990, only the pickup plate (cam sensor) in the distributor. how about a 1991?
How do I change a 305 cam sensor?
To change a 305 cam sensor, locate it beside the camshaft. Disconnect the electrical plug of the sensor and remove the hold-down bolt to take off the cam sensor. Replace with new.Ê
How do you replace cam sensor on 98 volkswagen golf?
Chek
How do you fix a P0340 code?
Test/replace the cam sensor.
