You need to pull up the center console cover first. Working from front to back carefully pull up to disengage the six pressure clips. You may need to disconnect the traction control wiring connection if you have one. The cup holder is attached to this panel and you can see how to repair or replace it. On my 1999 Regal the cup holder swing out side piece with the little spring fell off. I was able to retrieve them from under the console. Took me a few minutes to figure out how to put it back and re-engage the little spring. I added tape to secure cup holder top piece to the base to prevent them from separating again. Reattach the traction control wire clip and carefully push down to resecure the console panel. I believe the same Regal console panel fit from 1997 to 1005 model - but please verify that. Good Luck!
were can i locate and replace a starter for a 1998 buick regal?
How do you replace the morror assembly for a 2001 Buick Regal
How do you replace the fuel filter on a 2003 Buick Regal?
how to replace a radiator in a 1996 buick regal
The cup holder may snap out depending on which one it is. If the cup holder is a flip out style from the center arm rest then in has small ears that hold it in.
You have to get it from a Buick dealer.
how to replace master cylinder on 1996 buick regal
how to replace windsheild washer pump 2003 buick regal
no
junk it
how much does the resonator in the buick regal 99 cost
I have a 2000 Buick Regal GS how do I change my front sway bar