My bulb has been out since the vehicle was purchased and it wasn't until I was installing an after market radio when I got curious and wondered if indeed there was a bulb.Once you have the middle console off you keep taking screws off and making your way up towards the vents.Once you get to the vents your going to see that this one is not as easy as the other 3 pieces and this one goes all the way across to the other side of the steering wheel. You going to have to unclasp that big plastic molding under the steering wheel to expose 3 more screws. Okay now that that's off your going to see that behind the clock all that's holding it top the plastic is 2 screws.Unscrew the 2 screws holding the clock. Now you should be holding the whole clock assembly and you could see that all four side have clips holding the 2 halves together.Try and unclasp theses as best as you can to get inside.Once opened you can see the plastic/ glass time display has an arc that in that arc you can see the LED bulb ( the bulb has a blue rubber coating on the bulb).So indeed there is a bulb to light the clock (even the dealership tolled me that there is no light bulb.) Once opened you have the circuit board exposed and you can see that the LED is in a plastic little mold holding it to the board and if you twist this off it'll come off the circuit board.Now I could not find this replacement piece no where so I took the bulb off the little plastic mold by undoing the prongs that twist into it then took it to Radio Shack and got a replacement bulb and just had to twist the new prongs around the plastic little mold the same way the old ones were.And wallah! I now have my clock light up and working again.
Will Guzman
2002 Isuzu Rodeo
If it's like mine then it don't have a backlight.
2004 3.5 Isuzu rodeo 2wd reduce power light
The check trans light may light up in an Isuzu Rodeo, because there are problems with the transmission, The light will show up on the cars dashboard.
The four wheel drive light is most Likely staying on when your Isuzu Rodeo is in two wheel drive because of a bad sensor. A licensed auto technician would be able to replace this for you.
The oil light could be blinking in an Isuzu Rodeo because it is time to get the oil changed. This could also occur if the oil is low.
4x4 indicator light
If its the bulb you have to unscrew the light cover and pull out the old bulb and put the new one in.Then screw the cover back on.
Remove the decorative cover from the face of the clock. Remove the retaining screws from the clock. The light will be in the back of the clock. Push the light in and turn at the same time to remove the light. Reverse the process to install the new light.
that depends on the model year of the rodeo. If its a 92/93/94 remove the guage housing module(see how do i remove the dash board of a 93 rodeo) Once the module is out the front and rear panels of it will pop off with a screwdriver and you can replace the bulbs.
1157
disconnect the battery
My check engine light has been on for one month but last night my check trans light flashed off and on about 3miles till I was home. Why and what do I need to do? I have a 2000 Isuzu rodeo.