this may sound a bit crazy but you can usually reach the dash bulbs if you can get somewhat upside down in the seat so your basically resting your head against the break pedal looking up into the the backside of the dash, not very comfortable, but if you can reach them from that position you can turn them about a half a turn and they should come right out.
You can't and will have to buy new ones or replace the instrument panel with a used one.
The timing belt on a 1991 Plymouth Acclaim is replaced by removing the engine accessories, removing the timing cover, and taking pressure off the idler pulley. The belt can then be slipped off the sprockets, a new belt put in place, and the tension restored.
I changed mine by removing the battery. Then you can get your sockets and wrench into this space and take out the two bolts holding it on.
To remove and replace the heater core on the 1987 Nissan 300ZX with air, begin by removing the dashboard totally. This means the radio panel and the instrument cluster. Remove all air ducts and access the heater core. Remove the bolts holding the core and replace it with a new core. Then replace the dashboard and instrument panel.
Could be, Accelerator pump in carburetor is not working, (rebuild carb) Timing is off, (adjust timing) Vacuum advance not working, (replace vacuum advance unit) Points are in need of replacing or adjusting,
how do you replace the camshaft position sensor on a 1997 plymouth voyager 3l
You have to replace the fuse for it You have to replace the fuse for it
A Plymouth Voyager does not have a maf sensor.
install timing belt on 1993 Plymouth sundance
I have not received an answer to my question, "How do you replace a heater core in a 1995 Plymouth Voyager SE? When can I expect an answer? Thank you!!! nellkat60
By removing boards
belt assembly for a 95 Plymouth voyager
To replace a 1988 Dakota heater core, first discharge the A/C. Then remove the lower instrument panel before removing the heater box unit.
The easiest way to change the switch is by removing the instrument cluster to access the switch. Then you just unplug the switch and remove the 2 screws holding it in place.
A turn signal indicator can be replaced by first removing the burnt out light inside of the glass chassis. The new bulb will then be installed in the same fashion.
You can replace the timing belt on a 1998 Plymouth Breeze 2.0 engine using a Harmonic Balancer Puller 5.
you must remove the fuel tank to replace the pump.
You have to replace the entire instrument cluster.
you have to replace the t.p.s (throttle positioning sensor ) that's how i fixed the idle on my Plymouth breeze
take it in
the wire is bare how do you replace the wire with out removing the dashboard on a 1993 Chevrolet corsica?
If the VSS is defective replace the instrument cluster.
what you do is remove the instrument cluster (pop the cover and unscrew the cluster) put it on a bench face down then all you need to do is remove the clip holding the bulb in place.
I located the instrument panel illumination lights on my 1990 Nissan D21 Pick-up by removing the clear plastic panel that protects the gauges and pulling the instrument panel forward. To do this, screws must be removed from the dash panel located around the instrument panel. There are also screws securing the clock adjustment knob and the glass/instrument panel itself. The bulbs twist into the backside of the instrument panel. There are several of them. I located the instrument panel illumination lights on my 1990 Nissan D21 Pick-up by removing the clear plastic panel that protects the gauges and pulling the instrument panel forward. To do this, screws must be removed from the dash panel located around the instrument panel. There are also screws securing the clock adjustment knob and the glass/instrument panel itself. The bulbs twist into the backside of the instrument panel. There are several of them.