0
What else can I help you with?
What is the correct timing marks for a 1993 Plymouth sundance?
tdc 12 degrees
Where do you get a wire diagram for 1993 Plymouth sundance?
When changing anything, concerning wiring on a car, it is important to have a diagram. A wiring diagram for a 1993 Plymouth Sundance can be found in its maintenance manual.
Where is the turn signal flasher located on a 1993 Plymouth Sundance Duster?
Under the dash, driver seat side of the parking brake.
How do you access the fuel pump on a 1993 Plymouth sundance?
You have to lower the fuel tank.You have to lower the fuel tank.
Transmission fluid capacity in a 1993 Plymouth sundance?
According to the manual, the automatic transaxle Drain and refill takes 4 qts. (3.8 liters); From dry including the torque converter) 8.9 qts (8.4 liters)
What is the correct timing marks for a 1993 Plymouth sundance?
tdc 12 degrees
Where do you get a wire diagram for 1993 Plymouth sundance?
When changing anything, concerning wiring on a car, it is important to have a diagram. A wiring diagram for a 1993 Plymouth Sundance can be found in its maintenance manual.
What is the oil capacity on a 1993 Plymouth sundance?
4.5 quarts
How do you set timing on 1993 Plymouth sundance?
To set the timing on a 1993 Plymouth Sundance, first ensure the engine is at operating temperature and then disconnect the timing connector (usually found near the ignition coil) to allow for proper timing adjustment. Use a timing light to check the timing marks on the crankshaft pulley against the timing specifications indicated on the engine's timing cover. If adjustment is needed, loosen the distributor hold-down bolt and rotate the distributor until the timing light indicates the correct timing mark. Finally, recheck the timing and reconnect the timing connector.
What oil does a 1990 Plymouth sundance use?
5w30 should work fine. I have a 1993 sundance duster and that's what I use.
Where is the fuel pump located in a 1993 Plymouth sundance?
It is mounted in the fuel tank.
How do you line up the timing for a 93 Plymouth sundance?
To line up the timing for a 1993 Plymouth Sundance, first ensure the engine is at top dead center (TDC) on the compression stroke for cylinder one. Remove the distributor cap and check that the rotor is pointing to the correct terminal for cylinder one. Adjust the timing by loosening the distributor hold-down bolt and rotating the distributor until the timing mark aligns with the specified degree on the crankshaft pulley. Finally, tighten the distributor bolt and recheck the timing to ensure it remains in place.
How do you replace headlight bulb on 1993 Plymouth sundance?
To replace the headlight bulb on a 1993 Plymouth Sundance, first, open the hood and locate the headlight assembly. Remove the retaining clips or screws securing the headlight assembly and carefully pull it out. Disconnect the electrical connector from the back of the bulb, then twist and remove the old bulb. Install the new bulb by reversing the process, ensuring not to touch the glass with your fingers, and secure the assembly back in place.
Where is the fuel filter located on a 1993 Plymouth Sundance?
underneath right side by fuel tank
Is the 2.5 liter motor in a 1993 dodge sundance interference or no-binterferenceb?
The 2.5-liter motor in a 1993 Dodge Sundance is an interference engine. This means that if the timing belt fails, the pistons and valves can collide, potentially causing significant engine damage. It's essential to maintain the timing belt and replace it at recommended intervals to avoid such issues.
1993 sundance and you lost the keys - how can you replace the keys?
Locksmith
1993 Plymouth sundance duster wont start you have already gotten a new starter and a starter relay and a ignition time delay relay what now?
I replaced the battery in my 1993 sundance noe the starter will not ingage
