To set the timing on a 1993 Plymouth Sundance, first ensure the engine is at operating temperature and then disconnect the timing connector (usually found near the ignition coil) to allow for proper timing adjustment. Use a timing light to check the timing marks on the crankshaft pulley against the timing specifications indicated on the engine's timing cover. If adjustment is needed, loosen the distributor hold-down bolt and rotate the distributor until the timing light indicates the correct timing mark. Finally, recheck the timing and reconnect the timing connector.
It is computer controled and not adjustable.
To set the clock on a 1993 Plymouth Sundance, first, ensure the ignition is in the "Run" position. Locate the clock setting buttons on the dashboard; typically, there are two buttons labeled "HR" (hour) and "MIN" (minute). Press the "HR" button to set the hour and the "MIN" button to set the minutes until the correct time is displayed. Once set, the clock will retain the time even when the ignition is off.
You need a timing light
You need a timing light
yes.
Timing is set by the PCM and is not adjustable.
Get a manual on your car.
Hoo I set the correct timing on a 1993 mazda protege
How do you disconnect the Data Port when setting the timing on a 1993 Toyota Corolla?
Timing is set by the PCM and is not adjustable.
how do you set the timing on a 1993 Chevy pick up
To set the timing you unplug the temp. sensor in the thermostat housing and set the timing to 12 degrees before T.C. with the automatic trans.