0
How do you replace a crank position sensor on a 2000 Grand Prix?
Wiki User
∙ 18y ago
The crank position sensor is behind the crank pulley. You need to remove the pulley, remove the plastic shield and remove two of the lower front cover bolts. Then you can remove the crank sensor. This proceedure is more complicated than it sounds. Check out the following website for a cam install and scroll down to where it talks about removing the harmonic balancer (crank pulley) http://www.mccgp.com/upgrades/caminstall/caminstall.php Hope this helps. "G"
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
How do you replace a crank position sensor on a 2001 Mitsubishi galant?
Where is the crank position sensor 0n a 2001 mitsubishi Galant
Where is the camshaft position sensor on a 1993 4.0 L Grand Cherokee LTD?
On the top of the bell housing. thats the crank position sensor the cam sensor in a 93 is fixed in the distributor to replace it you need a new distributor
Where is the crank position sensor located on a 1993 Infinity G20?
trying to replace crank position sensor but i have no ideal where to look it is 1993 infinity G20 could you help me find this sensor
Where is the crank shaft position sensor on a Grand Am 1996?
DOWN BY THE OIL FILTER EASY TO DO
Where is the crank position sensor on a 87 Grand National?
on the harmonic balancer in the front of the motor it's a little window sensor
How do you change crankshaft position sensor?
where is the crank shaft pistion sensor located on a 2002 Chevy Malibu, and how hard is it to replace
Where is the crank position sensor for a 95 blazer?
Where is the crank position sensor hole on a 2003 Blazer
2001 jeep grand Cherokee won't start sometimes?
crank or cam shaft position sensor is sometime the issue.it will not fuel if it cannot find the position of the cam or crank
How you replace a crank position sensor 1997 BMW 528i?
Bmw 528 1997 not start
How do you repair the crank signal so that the engine will continue to run?
replace cam position sensor
How do you replace a crank position sensor in a hummer h2?
its behind the starter, disconnect the battery to begin with!
What would cause your jeep grand Cherokee to turn over but not start?
Bad crank position sensor
