There are two. The front cover seal, and, the rear main seal. The front..remove the drive belt,Remove the crankshaft pully BUT DONT TURN THE ENGINE COUNTER CLOCKWISE!! You may get slack in the timing chain and screw-up the timing!That is a HUGE mistake..After removing that bottom pully, pry it out,but be careful not to hurt the cover or the sealing surface.The rear main seal you must separate the transmission from the engine.Then remove the flywheel. Good luck, it's possible but a big pain in the ***.
How do you replace timing chain & water pump on a2001 Chevrolet cavalier
how do i get a replacement key for a 2001 chevy cavalier
how do you change a thermostat sensor in a 2001 Chevy cavalier and where is it
Does 2001 Chevy cavalier have a fuel shut off switch
will 2001 2.2 cavalier interchange engine parts with a 2000 cavalier
I got an estimate today at Car-X. $220.00.
Yes
The 2001 Chevy Express Van crankshaft sensor will be on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft sensor.
how do i replace the hub assembly on a 1997 cavalier 2.3 Ls
you have to take the gas tank off to get to it and if you need to replace the fuel filter they have to be spechial orderd.
The crankshaft sensor on a 2001 Chevy Silverado 8100 is located on the bottom of the engine, near the starter. It constantly monitors where the crankshaft is in its rotation.
Yes