You will need a 30mm socket for the spindle nut. Raise vehicle,remove tire,brake caliper. there is no need to remove brake pads. rotate caliper and pads off rotor. Remove caliper bracket and rotor. Remove the 3 bolts securing bearing to steering knuckle,engage from the rear of the bearing. requires a 15mm socket. You may need to turn steering wheel to the right and left to access bolts. Using a sledge hammer knock off wheel bearing at flange. Do not worry if you see copper wire,it's part of ABS system built into wheel bearing,your new one will have it included. clean seat where wheel bearing was located.
Pay attention to the position of ABS wire on new hub when reinstalling. put it back they way it came off!!!!
Installation is reverse.
I have done Two of these. The first time it took Two hours. The second 45 minutes.
A word of advice! Replace both bearings at the same time. The other will not be far behind.
The front wheel bearings, of a Pontiac vibe, can be replaced by first removing the front wheel. Next, remove the axle end cap. Remove the bearing and reverse the process to install the new bearing.
front or back? 2wd or awd? what year?
Take off the steering knuckle and press out the bearing and hub.Have the new bearing pressed in with the hub and re install the knuckle.
how to replace front wheel bearing on 1996 Hyundai elentra
To replace the alternator you must tip the motor. by removing the motor mounts in front on the motor.just the two top ones and than roll the motor forward. that will give you enough room to remove the alternator
You can replace the front bearing on 2003 Citroen Relay using air tools.
I found this page with a decent step-by-step process to help guide me in replacing my LH Front Wheel Bearing Assy on my 99 GrandAM GT. It shows how to replace one on a Grand Prix, but they are extremely similar. http://www.paulstravelpictures.com/GM-Wheel-Bearing-Hub-Assembly-Replacement/index.html
you can replace it by taking it to the shop and they will do it for you.
To replace the front wheel bearing on a Ford Fiesta, you will need to remove the wheel. Then with a hammer you can pull the old bearing out.
How do you replace passenger side fender on a 1998 pontiac bonneville se
Take wheel off, put bearing in
Get a manual for this vehicle.