Want this question answered?
It is very easy to check the transmission fluid level in a 1995 Dodge Avenger ES. You will need to park the car on level ground and keep it running while checking the fluid level. The dipstick is located where you put the transmission fluid.
The far right side of the instrument cluster. Or, did you mean the fuel level sending unit? That's located inside the fuel tank and is part of the fuel pump module. To replace the sending unit you have to replace the entire fuel pump module, which means removing either the fuel tank or the truck box.
To replace the fuel level sending unit, you must replace the entire fuel pump module, which is located inside the fuel tank. Unfortunately, to do this requires either removal of the fuel tank or removal of the truck box. One method is about as much headache as the other.
Check oil level install manual gauge to get accurate reading
Refer to repair manual for proper instructions Remove gas tank remove sending unit replace with new sending unit and properly reinstall sending unit and gas tank
The sensor screws into the side of the oil pan. You will need to drain the oil and then replace the sensor.
yes
It can be a bad sending unit or it can be low oil pressure. Start by replacing the filter with a Motorcraft filter if you have a Ford or Purolator if you have a Dodge, and making sure you are using the recommended weight of oil. If the problem still exists then replace the sending unit.
Replace sending unit which is located inside gas tank (gas tank must be removed from car).
diagnostic code 72 means the catalitic converter efficiency is below the required level.
You can't. Dodge Dakotas use an integrated fuel pump/filter/level-sending-unit module located inside the fuel tank. To change the filter, you must replace the entire fuel pump module which requires either removal of the truck boxbed or the fuel tank.
The Sprinter does not have an oil pressure sensor. The oil level sensor mounts to the side of the oil pan.