0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you change a bearing in a centrifugal pump?
A centrifugal pump is used on board most ships. There are many steps to overhaul one such as drain the pump, open the casing, remove the coupling, and replace the worn parts.
How do you fix a power steel leak on a Jeep Cherokee 1996?
Think you mean power steering. Leak will usually be in a hose, coupling or pump. Replace the item that is leaking.
Why does Furnace shut off when very cold outside?
A heat pump will do this, a furnace should not. Are you sure you have a furnace?
When would an oil furnace use 2 supply lines?
If you see two oil lines going to your oil furnace, most likely one is a supply line and the other is the return line to the oil tank. When it is necessary to lift oil to the burner, a return line should be connected between the fuel pump and tank. This requires insertion of the bypass plug into the fuel pump.
What causes pump coupling damage?
loose couplingsmisaligned pumpsexcessive vibration
Heat pump Or gas furnace and AC unit which system to install?
Your location matters. If in Florida heat pump in more northern climes furnace & ac.
Why does furnace and heat pump run constantly?
Could be a few things, the house being cold, a broken temp sensor, disconnect between the sensor and the furnace/pump.
What is scoop coupling?
Scoop coupling is nothing but a fluid coupling works based on the hydro dynamic principle. Scooping is the collecting the oil from the working chamber(space between pump wheel and turbine wheel) which will effects the transmission.
When the oil supply is above the oil burner pump and the pump ans supply would normally be a?
l
How do you prime the RUUD furnace when it runs out of fuel?
THE PHRASING OF THE QUESTION IMPLIES OIL IS THE FUEL USED. IF OIL, ON THE SIDE OF THE PUMP IS A BLEEDER. PUT A SHORT HOSE ON THE BLEEDER NIPPLE AND CRACK THE FITTING ABOUT 1/4 TURN CCW. PUT THE BURNER INTO A CALL FOR HEAT TO TURN THE BURNER MOTOR (WHICH DRIVES THE PUMP), ON. WITH THE HOSE IN A SMALL CAN (CUT THE TOP OFF A COKE CAN), RECYCLE THE BURNER TILL ONLY OIL COMES OUT, NO AIR BUBBLES. THE BURNER CONTROLLER WILL ONLY ALLOW THE UNIT TO OPERATE FOR SO LONG BEFORE THE SAFETY TRIPS. LET IT COOL (1-2 MIN) BETWEEN ATTEMPTS. PUSH THE RED BUTTON TO RECYCLE THE BURNER CONTROL. CLOSE THE BLEEDER WHEN DONE AND CHECK FOR LEAKS. LC
Why is your oil burner off but you still have heat coming from the baseboard?
A baseboard heater runs through a process of induction and release, in a manner of speaking. That is, the burner will heat the water; the water will pump through the system; and once all is up to temperature, the burner will shut down. However, the metal of the pipes and the water itself will not cool right away; it will remain hot for a time and cool slowly. The closer the baseboard is to the furnace itself, the longer it will remain hot.
Does a furnace have gears?
Most do not. Some may have gears in the fuel pump. A coal fired furnace may have a screw to feed in the coal.
