The price to replace a blown head gasket on a Chrysler Sebring V6 should be around $1,000.00. The price can vary depending on where you have the repairs made or if you replace it yourself.
It requires replacing the head gasket.
It should be on the drain plug.
Water pump gasket, head gasket, water tube,
Take it off, replace the gasket
Remove intake and exhaust manifolds, and then remove the head. This is a major repair that should only be attempted by someone who is competent.
Expect to spend from $800 to $1200.
you need to take the intake maniflod off, and the 2 screws on the back of the manifold. total time 2.5 hours, replace intake gasket or reseal it...
replace head gasket
You can change a head gasket if that is all that is wrong.
Possible failed valve cover gasket.Possible failed valve cover gasket.
To replace the oil pan gasket on the Cavalier you need the tool box to open where it is located. After opening, you can proceed to replace the oil pan gasket.
number #1 spark plug is located (if u are looking under hood) right side first one closest to you. NOTE* TO REPLACE SPARK PLUGS ON A CHRYSLER 3.5 LITER V-6 YOU MUST ALSO REPLACE UPPER PLENTIUM GASKET!!!!
Two likely causes are a failed water pump or a failed head gasket.
In short you have to take the head off, replace the gasket/s and replace the head. You best bring it to a pro.
AnswerWhen looking at the engine, the thermostat is located underneath the the radiator fill cap. There are 2 bolts to remove. Be careful not to rip or tear the gasket or make sure you have a replacement.On the 2.7L, the thermostat is under the housing where the lower radiator hose hooks to the engine.
Air leak in upper manifold, use a double gasket, problem solved! throttle cable stuck,
sway bar must be disconnected so you can move it out of the way
Follow the hose from the top of the radiator back towards the engine, where it connects is the thermostat housing, this can be removed by taking out the 2 bolts. - remember to replace the gasket!
Remove upper and lower engine intakes. Tie back or label tubes so not to loose reconnections. Once everything is remove the gasket is exposed. Pull gasket replace, then return intakes and labeled tubes.
You have a blown gasket somewhere. Probably a head gasket. These 2.7 litres are notorious for the water pump bearing failures these water pumps are very expensive to get replaced since their timing chain driven
Causes include low coolant, inoperative radiator fan, plugged radiator, stuck thermostat, water pump malfunction, head gasket failure.
Low coolant, inoperative radiator fan, failed water pump, restricted radiator, head gasket failed, stuck thermostat.
JUST HAD BBOTH DONE IT COST $1336.OO