answersLogoWhite

0


Best Answer

youll need to pull the dash out, its a lot of work, then disconnect the heater core hoses under the hood and change it the put the whole dash back in

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace a heater core in a Ford Ranger 3.0 L V6 automatic transmission 2WD?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace a heater core in a 1998 Ford Ranger manual transmission 2wd?

Take it to a mechanic and say "will you fix the heater core?"


How do you fix a leaky heater core in a 1996 ford ranger?

Replace it with a new one.


1988 Ford Ranger 2.9 V6 no heat?

replace the heater core if that's not it start checking fuse


How do you replace the heater coil on a 1997 F-150 2-wheel drive automatic 4.6?

You have to pull the dashboard to get to it.


Where is the computer located on a 93 ford ranger?

The computer on a 1993 Ford Ranger is located in the dash in the center just above the transmission hump. The computer is located just below the heater control panel.


Your 1990 ford ranger has little heat?

One of these things is the cause. Thermostat stuck open, replace it. Heater core stopped up, backflush the hearter core, and service the cooling system. Heater temperature control valve defective, replace it.


How hard to replace the heater core in 1994 ranger how many hours?

took me about 2 days, you have to remove the dash completely to get the heater core out. I suggest paying to have it done. I sure will if it ever happens again


Why does your floor board get oily on your 1984 Toyota Camry?

My guess is a leaking clutch master cylinder. Does this have a Manual or automatic transmission. B Clear. I've seen this plenty of times. either the chutch master, the speedo cable, or the heater core. is this a sweet smelling fluid? can you touch the fluid and rinse it off with water? if so it is a coolant leak, if oil is still there, it is oil from the trans, either manual or automatic. if it is clear and becomes cloudy when applying water it is probably brake fliud from the clutch master cylinder, replace it. if it is red, it probably is from the cable on an automatic transmission, replace the cable. if it is red or green and washes off with water it is probably your heater core, good luck with replacing this unit.


How do you replace a heater core on a 1993 ford ranger?

you have to remove the dash to get to it, it would save alot of time and aggravation to have someone do it for you. sure it will cost, but trust me, it took me 2 days to replace mine


How do you replace heater core in 1995 Ford Ranger 40?

you have to remove the dash to get to it, it is well worth it to pay someone else to do it, it took me 2 days to do mine


Your blower does not work on your 1989 ford ranger?

Replace blower motor resistor usually located in the duct work or out in engine compartment in ductwork by heater motor.


How do you replace the heater core on a jimmy?

How do you replace the heater core on a jimmy?