answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you replace a ignition control module on 1986 bronco 2?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change ignition control module 1995 Buick Riviera?

Disconnect the battery. Remove the ignition coils. Remove the ignition control module that was under the coils, and replace it.


What if your 86 bronco ll will not start evn though you have replaced the battery and ignition coil?

it could be the control module


1983 ford bronco wont get spark from the coil any help please?

check the ignition control module.


What causes ignition control module to fail repeatedly in 1991 Ford Bronco 302 FI?

http://www.therangerstation.com/tech_library/TFI_Diagnostic.html Heat


How do you change the Ignition Control Module in a 1995 Blazer S-10?

Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.


Where is the location of the ignition control module on a Ford Focus?

You can find the Ford Focus ignition control module beneath the drivers side dashboard. The ignition control module will be above the accelerator pedal.


How do you fix no spark in a 305 v8 Chevy?

I would replace the ignition control module that's in the distributor.


Where is the ignition control module on a 1992 Crown Vic?

Where is the ignition control module located in my 1992 Crown Victoria


Where is the ignition control module in a 1997 mercury villager?

The ignition control module sit directly below the distributor.


Where is the ignition module on a 88 tracer?

ignition control module is under the distributor cap


Were is the ignition control module on a 2001 Mercury Sable 3.0 dohc?

Where is ignition control module on a 2001 mercury sable


Where is the ignition and distributor located on a 1990 Chevy Celebrity?

The 1990 Chevy Celebrity engine is distributorless, the ignition is handled by a combination of the engine control module(computer) and the ignition control module. You did not mention which engine the car has. If your car has the 4 cylinder engine the ignition control module is below the intake manifold at the rear of the engine. You can follow the spark plug wires to it. The coils are mounted to the ignition control module. If your car has the V6 the ignition control module is near the starter and again you can follow the spark plug wires to it. Again the coils are mounted to the ignition control module.