Oh JOY! So you must have a Jeep somewhere between 1987 & 1992 or 3 (I forget which year they moved the internal slave outside). Basically pull the Xfer case & transmission & bell housing so it can be accessed. Might as well think about a new clutch while you are in there too. It ain't fun! A poor design by someone out of touch with reality!
how to replace the slave cylinder on a 1993 jeep wrangler
How do you replace the clutch slave cylinder on a 1989 jeep wrangler
Remove the transmission to excess the inturnal slave cylinder
If you get underneath the jeep you can easily see, if the lines go directly into the bellhousing, then its internal, my jeep has an internal
Yo have to remove the transmission.
you have to pull the transmission
If you don't see it (I assume you're talking about the clutch slave cylinder) it's probably got an internal slave. An internal slave cylinder is located inside the clutch housing. Servicing of this unit will require removal of the transmission. Do not forget to replace the roll pin and retainer clip (if equipped) that holds the slave cylinder/release bearing assembly in place. On any vehicle with a hydraulic clutch, you can find the slave by following the hydraulic line from the master cylinder to it's end.
Yes, replace it.
yes it has one
It depends on whether it is an interior or exterior slave cylinder. Interior takes about 4 and 1/2 hrs while an exterior takes 1 and 1/2. approx.
my clutch is not working ..think the slave cylinder is bad ..135 , 000 miles ..
if slave cylander is bad, it must be replaced to fix it