0
Assuming you want to change a head light bulb, open the hood and notice the two tabs sticking up behind the head light assemblies. These two tabs hold the head light assemblies to the radiator support. Wiggle the two tabs up and out and the head light assembly will come out the front giving you access to remove the bulb sockets for replacing the bulbs.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What is the brake light number for a replacement on a 1991 Toyota pickup?
I am looking for the bulb number to replace a burnt out bulb on a 1991 Toyota pickup
How do you replace a heater core on a 1991 Chevrolet S-10 Tahoe pickup?
Get a manual on your car to do the job right.
Where is the fuel pump on a 1991 Chevrolet Silverado pickup?
It is in the fuel tank.
What is the bolt pattern for a 1991 Chevrolet Pickup?
5 on 5 for 1/2 ton
What could be the reason for smoke to come out of the light switch when it is pressed in a 1991 Chevrolet?
Short in switch or wiring. Get this repaired ASAP or you may have a fire. answer replace light switch
How many miles per gallon does a 1991 Chevrolet 1500 pickup truck get?
13 mpg
How do you replace the driver side mirror of a 1991 Chevy Pickup 1500?
Remove the inside door panel from your 1991 Chevrolet 1500 pickup truck. Remove the wiring harness from the mirror. Remove the driver side mirror retaining bolts. Reverse the process to install the new driver side mirror.
How do you replace an ignition switch for a 1977 Chevrolet truck?
n ignition switch on a 1991 Chevrolet astro vanAnswern ignition switch on a 1991 Chevrolet astro van
What will cause the brake lights on a 1991 Chevrolet pickup to stay on after the vehicle is turned off?
The brake light switch is under the dash, and whenever the brake pedal is touched the brake light comes on. If the switch has failed or is out of adjustment it will leave the brake light on.
How do you replace fuel lines on your 1991 Chevrolet silverado?
take it to the shop
Idle speed adjustment for a 1991 Chevy cheyene pickup?
replace the ecm
Bad frond end vibration on 1991 Chevrolet 1500 pickup only sometimes?
You need to replace your tie rods, pitman arm and idler arm. I had the same problem and it went away. Cost me about $120.00
