Oxygen Sensors
Nissan

How do you replace a oxygen sensor in a 1995 Nissan Ultima GXE model?

454647

Top Answer
User Avatar
Wiki User
2015-07-15 19:28:35
2015-07-15 19:28:35

It is located in the exhaust manifold{s}- It will have 1 for a four cylinder, and 2 for a V6. You will need a special socket available from just about any auto parts store.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

you take it to the people to fix it.

User Avatar

You need to take a wrench to loosen the oxygen sensor, then you will need to disconnect the cord. Once you have done that you will then pull out the old oxygen sensor.

User Avatar

how to replace the throttle position sensor on a 97 nissan altama

User Avatar

its screwed into the exhaust manifold,undo wire and unscrew at manifold.

User Avatar

To replace the oxygen sensor on a Honda Odyssey, first unscrew the sensor. Then use a 22 mm socket or 7/8 inch wrench to replace the oxygen sensor.

User Avatar

How do u replace the camshaft sensor for a 2000 Nissan xterra 3.3L and where is its locatoin

User Avatar

The 2002 VW oxygen sensor is quite simple to replace. Remove the wiring harness. The oxygen sensor will simply pull out.

User Avatar

To replace the oxygen sensor disconnect the oxygen sensor electrical connector. Use an oxygen sensor socket to remove the sensor. spray the sensor with penetration oil if it is difficult to loosen. install in reverse.

User Avatar

An Oxygen sensor does not reset. You have to replace them and yes they are expensive.

User Avatar

hi, my friend the cost to replace the oxigen sensor depends if you go to the Nissan dealership is about $120.00 for one oxigen sensor or you can go to the discount auto parts, will cost $70.00 and it's easy to replace. you can do yourself and save a lot of money!! but make sure what sensor is not working because your Nissan pathfinder have 4 oxigen sensor. one before the catalistic and one after the catalistic. but Nissan pathfinder have two catalistics.

User Avatar

If the Nissan truck is either a V6 or a V8, the oxygen sensor will be located in the manifold. Sometimes it will be placed just below the manifold.

User Avatar

It is very easy to find. It is at cat. inlet. you can see it from the top when you open the hood.

User Avatar

wich one it has two one on the manifold and the other one on the exhaust pipe

User Avatar

wich one it has two one on the manifold and the other one on the exhaust pipe

User Avatar

You bring it to a service station and tell them to replace the oxygen sensor.

User Avatar

how do you replace oxygen sensor of 2001 bmw 318 ci es

User Avatar

Did you figure out where this sensor is located

User Avatar

how many gaskets and which ones are needed when you replace the knock sensor on a Nissan frontier w/a 3.3l v6 engine?

User Avatar

Replace sensor and clear code.

User Avatar

can you tell me were the map sensor

User Avatar

Trouble code P0335 means:Crankshaft position sensor A circuit malfunction

User Avatar

It is located on the backside of the engine. Go to youtube and type in how to replace camshaft sensor on 2005 Nissan altima and it will show where it is and how to replace it, that is how I did my one.

User Avatar

The O2 sensor is located in the exhaust manifold on the front of the engine. To change it you'll need a 7/8 box-end wrench. Just unplug the wire from the harness, unscrew the sensor and replace it. It's pretty easy.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.