Want this question answered?
Front or rear?
Front is easy, just replace hub rear is pressed in
You can replace both... Bearing or Hub... Bearings are cheaper, but harder to find and replace. Hub assemblies are easier to replace, but slightly more expensive.
You replace it as part of the rear disc assembly. Remove rear wheel and hub nut cover undo hub nut,then remove the rear caliper and pull the disc off the stub axle.
nO
how hard is it to replace a rear wheel bearing 1999 Honda crv. this crv does not have rear axle's in it. thank you
The bearings are not replaceable, they are a part of the rear hub assembly - the studs and the bearings are pressed in - replace the whole hub assembly - 4 bolts are holding it. Rear bearing/hub bolts (new only) are to to be torqued to spec. [2000 Montana - 85 Nm (63 lb ft)]
taking out rear hub asembly on a 2002 Chevy ventura
The rear wheel bearings in a 2003 Buick Rendezvous are integrated with the hub, therefore they are only available/replaceable as an entire hub assembly. The rear hub assembly costs around $200/each, depending on the specifics of the vehicle (2WD or 4WD).
You need to replace the rear wheel hub - bearing and speed sensor inclusive
The front wheel bearing is a sealed unit with the wheel hub - replace the hub and wheel bearing unit. Remove the four bolts from the rear of the steering knuckle that connect to the hub bearing unit.
This depends on if you are replacing the front or rear wheel bearings. The front wheel bearings require that you remove the brake caliper and disc assemblies (this is required for the rear bearings as well) You will also need to remove the front driveshaft from the hub, after which the hub will unbolt and can be removed from the vehicle. S40's have the annoying habit of having the driveshafts rust into the hub, so you may have some difficulty with that. The rear hub assemblies are also removed in a similar way, except you don't have to remove the driveshaft as it wont have one! If you are replacing the bearings with genuine Volvo units they should come as a whole hub assembly, in which case all you have to do is bolt the new units in and off you go. However if you are just replacing the bearings themselves, you'll require the use of a heavy duty bech press to remove the bearings from the housing.