answersLogoWhite

0


Best Answer
Copy
1Disconnect negative battery cable. Remove the 3 bolts attaching the starter to the engine/transaxle. Remove the heat shield and its clamp, if so equipped. Remove the 2 electrical wire connector terminal nuts and remove the wiring connectors from the starter. Remove the starter from vehicle. Clean all wire terminals of dirt,grease or corrosion. Reattach the electrical wire connectors and secure with the mounting nuts. Tighten the starter solenoid B+ nut to 80 inch lbs, and the solenoid wire to starter nut to 55 inch lbs. Reinstall the heat shield if one was removed.
User Avatar

Wiki User

โˆ™ 2015-07-15 21:42:57
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you replace a starter in a 1991 Plymouth acclaim?
Write your answer...
Submit

Related Questions

Does the 1991 Plymouth acclaim have an interference engine?

No. A 1991 Plymouth Acclaim does not have an interference engine.


Where is voltage regulator in 1991 Plymouth Acclaim?

on alternator


Where is the starter located on a 1991 plymouth acclaim?

Four cylinder it is on the back, under the manifolds. Six cylinder, it is on the front under the exhaust manifold.


Where is the inertia switch located in a 1991 Plymouth Acclaim?

Plymouth does not use inertia/reset switches


How do you replace timing belt on 1991 Plymouth Acclaim?

The timing belt on a 1991 Plymouth Acclaim is replaced by removing the engine accessories, removing the timing cover, and taking pressure off the idler pulley. The belt can then be slipped off the sprockets, a new belt put in place, and the tension restored.


1991 Plymouth acclaim brake line metric or sae?

They are SAE


Was the 1991 Plymouth Acclaim a K car?

No it was had an AA body code.


What does the check the gas warning light on a 1991 Plymouth acclaim mean?

no what dose acclaim mean not gas and stuff


What is the oil capacity of a 1991 Plymouth acclaim 3.0 v6?

4.5 quarts


1992 Plymouth Acclaim what Refrigerant is to be used?

My 1991 Plymouth Acclaim manual says mine is R12, but I can't say for the '92 It was built with R12, should be retrofitted to R134a.


What is the Fuse amp for 1991 Plymouth acclaim radio?

10 amp... in socket # 20


When the gas light comes on how far can you drive in a 1991 Plymouth acclaim?

Until you run out of gas...


How do you replace starter on 2.3cy 1991 Pontiac grand am?

How do you replace starter on2.3 cy 1991 pontiac grand am


How many quarts of oil are used in a 1991 Plymouth acclaim?

4 1/2 with a new filter.


Where is the 1991 Plymouth acclaim mutifunction switch?

The lever you move to activate the turn signals is the multifunction switch.


Where do you add trans fluid Plymouth acclaim 1991?

Transmission fluid is added into the same spot that the dipstick is in.


How do you replace the headlight assembly located on a 1991 Plymouth Acclaim?

Its held in with 4 star shaped screws... just disconnect the headlight bulbs, remove the screws and install the same way that you took that out with.


Does a 1991 Plymouth Acclaim have a transmission filter?

Yes, the automatic transmission filter is located inside the transmission pan.


How do you change a starter gear in a 1991 buick lesabre?

replace starter


Where is the fuel pump located on 1991 Plymouth Acclaim 6cyl?

your fuel pump is located in the top rear of the fuel tank


What is trouble code 26 1991 Plymouth Acclaim?

Trouble code 26 in a 1991 Plymouth Acclaim is >>> the Peak Injector circuit voltage has not been reached (need to check computer signals, voltage regulator injectors.) Note: check computer connections! For further ECU codes check out http://www.freeautomechanic.com/diagnostictroblecodes8.html (freeautomechanic.com)


How do you replace drivers side window in a 1991 Plymouth Sundance?

you have to go to a mecanic.


How do you replace solenoid on 1991 Ford Escort?

The solenoid is part of the starter.


Does anyone have a fuse box diagram for a 1991 Plymouth acclaim v6?

Where the fuse box is, remove the panel and there should be a sticker on it, that shows what goes where, and what amp the fuse is.


Where is the ecm connection on your 1991 Plymouth Acclaim?

The ECM on mine (2.5L of that year) is to the right side of the battery, up against the frame, integrated with the air intake.