Chevy Astro

How do you replace a starter on a 1988 Chevy astro van?

111213

Top Answer
User Avatar
Wiki User
2014-10-07 02:14:07
2014-10-07 02:14:07

Remove the positive cable from your 1988 Chevy Astro battery. Remove the cables from the front of your starter. Remove the starter retaining bolts. Reverse the process to install the new starter.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

You should begin by removing the positive cable from your 1988 Chevy Corvette battery. Remove the cables from the front of the starter. Remove the three starter retaining bolts. Reverse the process to install the new starter.

User Avatar

It is mounted on the starter motor itself. When you get another starter, it will have the solenoid mounted on it already. If it is bad, just replace the starter, I would not change just the solenoid.

User Avatar

Remove the positive battery cable from your 1988 Chevrolet 1500 pickup truck battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.

User Avatar

The starter on a 1988 Chevy Celebrity is located on the bottom of the block at the bellhousing.

User Avatar

Disconnect the - battery cable Raise and support the vehicle Remove wiring at the top of starter Remove mounting bolts Remove starter

User Avatar

You can add power steering fluid to your 1988 Chevy Astro by removing the top to the power steering fluid reservoir. Pour the fluid directly into the reservoir.

User Avatar

I have a 2003 astro with the same problem, it was the blower motor

User Avatar

The starter is on the bottom of the block on the side nearest the radiator.

User Avatar

At the rear lower end of engine

User Avatar

on the roght side below the manifold

User Avatar

weighs in at about 4125, i just junked mine,

User Avatar

Fluid is added through the transmission dipstick.

User Avatar

NO Chevy did not make a 3 bolt starter. It only requires 2 bolts.

User Avatar

The starter solenoid is not disengaging once engine is started. Rebuild starter or replace with a new starter.

User Avatar

165432 is the firing order for the 4.3 L engine

User Avatar

Camshaft position is taken from the distributor, there is no separate sensor.

User Avatar

I've got a better question, why is this question in the Chevy venture forum ? they have completely different engines and belts

User Avatar

takeing it off and putting a new one on??

User Avatar

You should hope so. The other option is a damaged flywheel which is a much larger project than replacing a starter.

User Avatar

I think it is the same as the 1988 one that was previously answered. 1.6.5.4.3.2

User Avatar

This is a common fault in Chevy Astro, and reasonably easy to fix. I had to replace all in my 1988 and starting the process in my 1998. Chevy dealers stock these parts due to popularity. All you have to do is remove the inner door panel (you may want to also by a couple spare fasteners you break at this feat). Handles just bolt in and connect to control rods. Joe


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.