Oldsmobile Cutlass
DIY Projects

How do you replace a starter on a 1998 olds cutlass?

151617

Top Answer
User Avatar
Wiki User
Answered
2010-06-21 16:09:19
2010-06-21 16:09:19

how do you replace a starter on a 1998 cutlass

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


what is a 1998 olds moblie cutlass value

Disconnect the - battery cableRaise and support vehicleDisconnect wiring at top of starterRemove starter mounting boltsRemove starter

i need to replace the ecm on a 1993 olds cutlass supreme,can i replace it with another ecm from another olds cutlass?

How do you replace a axle on a 95 holds cutlass supreme

I have a 1998 olds cutlass and it is leaking cooling and have a bad ticking sound what do you think I should do.

how do you change a thermostat on a olds cutlass supreme 1983

Follow the pos battery cable and it is at the engine end.

follow the positive battery cable down to the starter solinoid which is mounted to the starter motor, the starter motor should be on the same side as the battery is. good luck

remove starter boltsremove cable and wires

where is the emc located on a 1988 olds cutlass?

if you buy a book it is simple 2 to 3 hrs

Where is the water pump on a 1995 olds cutlass supreme?"

how do you drain s 1999 olds cutlass radiatoe

Drop the gas tank and replace the fuel pump. It is on top of the fuel tank.

To replace a starter in a 1985 Olds car, raise the front end of the car with a jack, Next, remove the two support bracket bolts at the transmission and pry the support bracket away slightly to obtain access to the starter bolts.

The best way to find out is go to your local auto parts store, ask for a haynes or chiltons manual on your vehicle. This will tell you everything you need to know about working on your vehicle.

Open up the hood, look straight down and it's close to the bottom of the engine. you can actually see it with no problem.

The license plate light on a 1995 Olds Cutlass Supreme can be replaced by accessing the bulb through a hole in the bumper next to the license plate. A person may need to do this from underneath the vehicle.

It is located behind the starter. You'll need to remove the starter to replace it.

To replace the transmission fluid in the 1999 3100 V-6 Olds Cutlass, first remove the transmission drain plug from the underside of the vehicle. Drain all of the old fluid. Then, replace the drain plug and add new fluid through the transmission dipstick holder in the engine compartment.

The last rwd Olds Cutlass was the 1988 model.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.