The starter solenoid sits atop the starter. You will need to put the front of the truck up on ramps. Make sure you set parking brake and block rear tires for safety. Disconnect battery. The starter should be on the passanger side. Climb under truck remove the flywheel cover. Then loosen the two bolts that hold the starter. Be careful the starter weights a bit. When the starter drops there is the batter cable diconnect bolt, and a small wire hooked to solenoid with small nut, remove both and starter will come out. You may have t wrangel it a little to get out. Remeber you local library is a good source for Chilton Manuals or Motor Manuals which can walk you through the process.
where dose the transwmission control solenoid go on 1993 chevrolet silverado truck
On the starter.
Starter Solenoid? Located on top of starter Disconnect electrical connection between starter and solenoid--1/4 or 5/16 bolt on bottom of solenoid Remove 2 screws and twist--spring loaded
The starter solenoid is mounted directly to the starter. Just follow the positive battery cable from the battery, it will lead you right to the starter solenoid.
on the starter its self>>>>JAC
The solenoid is located on the passenger side on top of the starter motor.
It's attached to the starter.
On the starter.
how to replace starter 1993 88hp Johnson outboard
what kind of solenoid? The starter solenoid is part of the starter. The EGR solenoid is in the emmisions box on the firewall. The transmission shift solenoids are bolted to the top front of the transmission case
Follow + battery cable should connect to solenoid
1. Disconnect the negative battery terminal 2. Remove the air intake duct and the air cleaner box from the engine compartment 3. Disconnect the battery cable and the solenoid terminal from the starter solenoid 4. Remove the starter mounting bolts