Without knowing more details about the type and location of the sump pump it is hard to advise you what to do.
If you can log in again and provide more details someone may be able to give you a more helpful answer.
Replace water pump and gasket
You would need a sump pump repair if the sump pump in your basement is not pumping out water. The purpose of a sump pump is to drain excess water that is part of your waterproofing system.
how easy is it to change a oil sump gasket on a ford fiesta 1.4 diesel 2008
remove sump pan on gearbox replace with new one and replace gasket at same time then refill with correct oil.
You need to follow the same procedure as for timing belt replacement. But in the case of the oil pump you have to remove the oil pan too. There is a strainer attached to the oil pump from the bottom you will have remove it too. Then replace the oil pump, make sure that you have replace the oil pan gasket, and oil pump gasket.
If it is all that is wrong, then yes.
Remove all the oil of the sump through drain plug. Open all the mounting bolts of oil sump. If required, tap the oil sump so that it comes out. Check on which surface (Block or Sump) the gasket is pasted. Remove the gasket from the block/sump. Clean both the surfaces. Put the gasket on the sump and hold the same with the help of 2 bolts located in crossed direction. Screw in the bolts slowly and after inserting 3-4 threads, you can tighten the bolts with spanner/ratchet. Mount all remaining bolts and tight the same in cross directions. At last torque the bolts to the specified torque value that too in cross directions. Recheck the same at last.
To replace the water pump on a 1993 Ford Explorer, disconnect the battery and loosen the belt tension pulley. Remove the belt on the water pump. Disconnect the radiator hose from the pump and remove the bolts holding the pump. Remove the old pump and gasket. Clean the surface of the water pump mount with a gasket cleaner. Insert gasket sealer, new gasket, and pump. Reconnect radiator hose, belt, and tighten tension pulley. Reconnect the battery. Refill radiator with antifreeze.
To change the water pump simply remove the bolts from the waterpump, pull it off and replace with new. The power steering pump will need to be loosened and moved aside to remove one bolt. Clean old gasket from engine block and replace with new gasket and replace with new waterpump.
sump pump
There isnt one. Replace the gasket. Additives are worthless. If you add something to your coolant to clog gasket tears then what else are you clogging?? Water pump, heater core, radiator? Replace the gasket.
form_title=Sump Pump Installation form_header=11503 What is it you need a sump pump for?*= () Water leaks through walls () Basement floods during storms () Basement floods due to rising water table () In case pipe bursts or basement drain is clogged () Other () Don't Know Does the new pump location have electricity close-by?*= () Yes () No () Don't Know