Follow the top radiator hose back to the engine. There is where the t-stat housing is. Remove the hose, remove the housing, remove the old t-stat, clean gasket surfaces install the t-stat into the housing with the spring side sticking out toward the engine, use spray adhesive to attach the gasket(DO NOT USE RTV), reinstall everything and be careful to evenly tighten the housing bolts until they are snug(DO NOT RAUNCH HARD ON THE BOLTS). Fill the cooling system with a 50/50 mix of coolant and water, and burp the system.
15.00. for gasket and thermostat
A 1994 VR Commodore thermostat housing is located where the at the end of the large lower radiator hose. There will be a small housing with two screws. Be sure to drain the coolant before attempting to remove the thermostat.
4 bolts are romoved from the backsode of the steering wheel. If airbag equipped remove airbag fuse first. Then remove airbag/ horn/ center assembly. Remove large nut from center of wheel, then pull wheel with steering wheel puller.
i dont know about a diagram except if you have a chilton book on the car. but you should have a thermostat in the front housing,whear the top radiator hose meats the head,just take the tow bolts out-it should be in thear. you should also hav one on the back of the head whear the lower radiator hose meats the head.
Just replace it, it's not expensive.
On your 1994 MERCURY TRACER, the THERMOSTAT is: UNDER HOOD, DRIVER SIDE, UPPER ENGINE AREA, ENGINE END OF UPPER RADIATOR HOSE, MOUNTED IN COOLANT OUTLET HOUSING. The upper radiator hose will lead you to the thermostat housing as described above. It is much easier to access if you remove the distributor which sits above the thermostat. Mark your plug wires if you unplug them.
100,000 miles
What is the motor size? Run1
It should be located on the evaporator case.
What is the motor size? Run1
where is the thermostat
The engine oil pan is bolted to the bottom of the engine on your 1994 Mercury Tracer
0.054
disk It has both.
You can't. Computer sets it. Chuck the Tracer pro.
I do not know, but I am having the same problems with the removal of my 1994 tracer's stereo
0.054