0
Do an online search for a shop manual. Try http://www.ebooksquad.com
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you remove transmission cooling lines from the radiator on a 2000 Chevy venture?
Use a flared end wrench or crows foot to loosen.
Can you replace a 94 Chevy van rear end with a Chevy Suburban rear end?
It can be done, yes.
How do you replace a fuel system regulator on a 2000 Chevy Cavalier Z24?
Remove the fuel rail.It is on the end of the fuel rail with a vacuum line attached.
How do you repair vacuum hose for Chevrolet venture 2000?
The best way to repair a vacuum hose on your Chevrolet is to replace the vacuum hose. The vacuum hose is held in place with a retaining clamp on each end of the hose.
How do you replace a fuel filter on a Chevy Venture?
filter is located under the van on the driver side approx the middle of the van. It has those quick disconnect fittings on each end and will leak some fuel when you take it loose, so be careful
What is the app. price for fixing a front end bearing on a 2000 Chevy venture?
just did mine in Canada it cost me almost $700 to do both sides with discount on labor and parts...mechanic felt bad for us because we had to do both sides at same time.
Why doesn't my Cruise control on Chevy venture mini van work?
Most likely the plastic piece on the end of the cable broke off under the hood where it connects to the throttle body. This is a common problem on the Venture. Just go buy another one at the Chevy parts counter and pop it on.
Where is the thermostat located on a 1996 Chevy Venture?
On the engine end of the upper rad hose. When replacing it make sute the spring goes toward the engine.
What causes wear on the inside of a front tire of a 2001 Chevy venture?
Front end is out of alignment. Take it to a trusted alignment shop and have an alignment performed.
When did Venture Stores end?
Venture Stores ended in 1997.
Where is the flasher unit located in a 2000 Chevy Venture van?
Hi, The flasher unit is mounted above the base of the steering column. It will look like a little square or rectangle and will plugged into the end of a cable. You will have to remove the knee bolster on the driver side to get to it. Good Luck, Greg
How do you tune up a 2000 Chevy S10 4 cylinder at the distributor end?
It doesn't have a distributor.
