Do an online search for a shop manual. Try http://www.ebooksquad.com
Use a flared end wrench or crows foot to loosen.
To jump-start a 2000 Chevy Venture, first ensure both vehicles are turned off. Connect the positive (+) jumper cable to the positive terminal of the dead battery, then attach the other end to the positive terminal of the working battery. Next, connect the negative (-) jumper cable to the negative terminal of the working battery, and the other end to an unpainted metal surface or ground on the dead vehicle. Start the working vehicle, let it run for a few minutes, then try starting the Chevy Venture.
It can be done, yes.
Remove the fuel rail.It is on the end of the fuel rail with a vacuum line attached.
The best way to repair a vacuum hose on your Chevrolet is to replace the vacuum hose. The vacuum hose is held in place with a retaining clamp on each end of the hose.
filter is located under the van on the driver side approx the middle of the van. It has those quick disconnect fittings on each end and will leak some fuel when you take it loose, so be careful
just did mine in Canada it cost me almost $700 to do both sides with discount on labor and parts...mechanic felt bad for us because we had to do both sides at same time.
Most likely the plastic piece on the end of the cable broke off under the hood where it connects to the throttle body. This is a common problem on the Venture. Just go buy another one at the Chevy parts counter and pop it on.
Front end is out of alignment. Take it to a trusted alignment shop and have an alignment performed.
On the engine end of the upper rad hose. When replacing it make sute the spring goes toward the engine.
Venture Stores ended in 1997.
Hi, The flasher unit is mounted above the base of the steering column. It will look like a little square or rectangle and will plugged into the end of a cable. You will have to remove the knee bolster on the driver side to get to it. Good Luck, Greg