jack up the caravan and place it on jack stands, remove the passenger side tire, take out the three bolts on the pulley. then side a floor jack with a block of wood under the oil pan where it curves at because that is the strongest point. jack up the engine just a little so that you can remove the top motor mount bolts on the passenger side. once the motor mount is loose then lower the jack slowly so the motor tilts at a angle. then you drain the water out and remove the pulley and then the bolts from the water pump to block. clean surface good and replace with a new water pump and seal, and then just go in reverse order .
very carefully.
I can get to it but how does one get it out?
Drain the water from your 1991 Dodge Caravan 3.3 liter engine cooling system. Remove the water return hose from your water pump. Remove the water pump belt. Remove the water pump retaining bolts. Reverse the process to install the new water pump.
The water pump on a 3.0L is inside, driven by the timing belt.
yes
I did mine, first time on this vehicle, in an hour .
behind the timing cover you should change the timing belt when you change water pump.
The water pump is located inside the front of the engine, driven by the timing belt.
how do i change a water pump in a 1991 dodge shadow with a 2.2 liter does it require an internal water pump
If it is a 3.0 liter, It is a very difficult job. Water pump runs off timing belt behind all the plastic panels and motor mount on front of engine. Haynes/Chilton book has the procedure but it is not for the mechanically challenged.
I paid about 200 last year- that was for parts and labor.
Where is the water pump???