You take it to autozone and they will show you
Raise the wiper blade and hold. Pull the release on the bottom of the blade and wiggle it off.
The 2001 Mercury Grand Marquis has the most common hook-end wiper arms. See sources and related links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.
Do you mean wiper arm or wiper blade assembly that's attached to the arm? Most people mean wiper blade so here's your answer: The 2001 Mercury Grand Marquis has the most common hook-end wiper arms. See sources and related links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.
stick the wiper blade up your hole - I can't figure it out either.
See Windshield Wiper Blade Replacement on page 6-40 of your "Owner's Manual", under Section 6: Service and Appearance Care.....
Replace wiper blade and carefully bend wiper arm so it makes good contact with windshield
To replace the wiper blades on a Mazda 626, first lift the wiper arm away from the windshield. Press the tab or button on the wiper blade connector to release the old blade, then slide it off the arm. Align the new wiper blade with the arm, slide it into place until it clicks, and lower the arm back onto the windshield. Repeat the process for the other wiper blade if needed.
are you serious... life blade off windshield, unclip plastic fastener off the center of the wiper arm, remove wiper, replace in reverse order.
wipers wiper blade windshield wipers
To remove the windshield wipers on a 2007 Scion tC, first lift the wiper arm away from the windshield. Locate the small tab on the underside of the wiper blade where it connects to the arm, press this tab, and slide the blade downwards to detach it from the arm. Repeat this process for the other wiper blade. Once both blades are removed, you can replace them with new ones if needed.
Razor blade
There is a tab you pull up on located at the top of the blade. When you pull it up the wiper should be able to slide off the wiper arm pin, replace with a universial blade.