This vehicle takes non-standard wiper blades so its best to ask the dealer since you'll have to get the wipers there anyway.
Raise the wiper blade and hold. Pull the release on the bottom of the blade and wiggle it off.
Replace wiper blade and carefully bend wiper arm so it makes good contact with windshield
stick the wiper blade up your hole - I can't figure it out either.
You take it to autozone and they will show you
How do I replace the windshield wiper switch?
See Windshield Wiper Blade Replacement on page 6-40 of your "Owner's Manual", under Section 6: Service and Appearance Care.....
There is a tab you pull up on located at the top of the blade. When you pull it up the wiper should be able to slide off the wiper arm pin, replace with a universial blade.
The wiper blade misses the windshield in the middle of the wipe. Is there an adjustment for that ? I have replaced the wiper to no avail.
Yes, you can get aftermarket online or at a store or OE (Original Equipment) from your dealer. The 1998 Jaguar XJ8 takes 21" replacement windshield wiper blades on both sides front.
The 2003 Jaguar X-Type has the most common hook-end wiper arms. See sources and related links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.
are you serious... life blade off windshield, unclip plastic fastener off the center of the wiper arm, remove wiper, replace in reverse order.
Turn the wiper switch to the on position. Turn the key on and as soon as the wipers go straight up then turn them off. That will make it easier to remove the blade. Lift the wiper away from the windshield while pulling down. Be sure to not let the wiper fall against the windshield. Push the new one in place and you are done.