The idle air control valve is located on the back of the throttle body. It has an oval electrical connector and two torx screws holding it in. Unplug the connector, remove the two screws then lightly tap the body with a soft faced mallet to loosen it from the body. Once you have it out and prior to installing a new valve clean the seat inside the throttle body where the idle control fits. This must be very clean! Installation is in the reverse order. Btw, to save some cash, pull the valve out and clean it, this usually fixes the problem for quite a while.
Go buy a Haynes Auto Repair manual for your car.
Look on you tube they have a video of doing this job
An idle air control valve is generally located on top of the throttle body, under the hood. Often, these valves need to be cleaned rather than replaced.
To change PVC valve on a 1993 Nissan 300zx, first remove the oil dip stick and remove the tension clip from the PVC valve hose. Then remove the hose and the old PVC valve. Replace with a new PVC valve.
The cruise control computer module is located on the passenger's side of the engine compartment on a 1993 Mercury Villager.
Some cars have no valve and you have to loosten the line to bleed the cyl. Fill the slave cyl as full as you can get it before mounting it .
The 1993 Pontiac Transport windshield wiper control module is located on the firewall in the engine compartment. The windshield wiper control module will be on the passenger side of the firewall.
how to change starter on Hyundai scoupe 1993 12 valve
Replace the PCV Valve.
i have cars that need to be repaired alot that's why i need this info.
The idle air control valve is on the the bottom of the throttle body.
The idle is controls ONLY by the PCM. Replace your ECTS along with cleaning the Idle Air Control valve located on the throttle body.
Replace valve seal
Yoshi's Safari happened in 1993.
Yoshi's Safari happened in 1993.
Detroit Safari was created in 1993.
The Control Module on a 1993 Camaro is just to the left of the valve cover. It is toward the rear of the engine compartment on the passenger side of the engine.
The diagram on how to replace valve covers on a 1993 Honda Prelude can be found in the service manual. If you do not have a copy of the service manual, Honda can provide itÊupon inquiry.
Replace spark plugs and wires Replace fuel and air filters Replace PCV valve
It is on the left side of the TBI Throttle body, and it screews into the side of it. with a electric connector plug on it. ( Idle speed control) The EGR valve is on the lrft side of the intake manifold, close to the valve cover.