0
How do you replace an ignition module on an eighty eight celebrity?
Wiki User
∙ 15y ago
if u a talking about a control module it is under the distrubitor cap and is held in place with 2 screws If it is a distributorless engine such as the 3.1L, the module is underneath the coil packs. There are 3 of them mounted towards the front of the engine. Follow the spark plug wires. They are two bolts on each coil pack.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you replace the Ignition Module in the Chevy Celebrity?
To replace the ignition module in your Celebrity: Unplug the wires, take note of where they go so you can put them back in the correct place. Remove the screws that hold the ignition module in place. If the old module was coated with dielectric grease on the mounting surface put fresh dielectric grease on the replacement ignition module. Put the new ignition module in place and attach with the screws. Plug the wires back in their respective places.
Can you change the distributerless on a 1989 Chevy Celebrity?
You can replace the ignition control module and the crankshaft position sensor as required.
Where is the ignition module on a 1986 Chevy Celebrity?
On the V6 the ignition module is under the distributor cap.
Where is the ignition module on a 1988 Chevy Celebrity 2.5?
The ignition module on a 1988 Chevy Celebrity with 2.5 engine is on the side of the block beneath the intake manifold. You can simply follow the spark plug wires to it. As information the crankshaft position sensor is behind the ignition module.
How do you replace an ignition module on an eighty five Chevrolet Celebrity?
The ignition module in a 1985 Chevy Celebrity it located in the distributor. To change the ignition module: 1. Disconnect the ground terminal on the battery. Wear gloves to avoid getting acid on your skin. 2, Remove the distributor cap and place it out of the way. If you pull any spark plug wires make note of where they go so they can be put back. 3. Carefully unlatch the electrical plugs and remove them. The latches are old and brittle, be careful not to break them off. Take note of which one goes where to be able to put them back. 4. The ignition module is held in with two screws, remove them and lift off the module. Use fresh dielectric grease on the replacement module. Coat the bottom of the with a generous amount of dielectric grease. This acts as a heat sink and will greatly improve the life of the module. Reverse the procedure to install the replacement ignition module.
Where is the ignition module on a 1989 Chevy Celebrity?
On a 2.8l v6 it is at the front of the engine behind the ignition coils.
How do you reset time on a 87 Chevy Celebrity?
All 1987 to 1990 Chevy Celebrity engines use distributorless ignition. Timing is controlled by the engine control module in conjunction with the ignition module. There is no provision for adjustment.
How do you change the ignition control module in a 1989 Chevy Celebrity?
Which engine does your car have?
Where is the ignition and distributor located on a 1990 Chevy Celebrity?
The 1990 Chevy Celebrity engine is distributorless, the ignition is handled by a combination of the engine control module(computer) and the ignition control module. You did not mention which engine the car has. If your car has the 4 cylinder engine the ignition control module is below the intake manifold at the rear of the engine. You can follow the spark plug wires to it. The coils are mounted to the ignition control module. If your car has the V6 the ignition control module is near the starter and again you can follow the spark plug wires to it. Again the coils are mounted to the ignition control module.
How do you replace ignition module in a 98' Malibu?
Remove the ignition module retaining ring. Pull the ignition barrel out. Remove the wiring harness from the back of the ignition barrel. Reverse the process to install the new ignition module.
Where is the ignition module on a 1994 Mercedes Benz SL-500?
am told my ignition module on my SL 500 is faulty where can i replace this and what exactly does it do?
How do you test an Ignition Module on a 2.5 L Chevy Celebrity?
I take mine to Autozone, they offer free testing of ignition modules.
