answersLogoWhite

0

am told my ignition module on my SL 500 is faulty where can i replace this and what exactly does it do?

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where is the location of the airbag module on 1994 Mercedes sl500?

In the 1994 Mercedes SL500, the airbag module is typically located under the center console or beneath the driver's seat. You may need to remove some trim panels or the center console to access it. Always ensure the vehicle is turned off and the battery is disconnected before attempting any work on the airbag system for safety reasons.


Where is the Mercedes Ignition Control Unit on a 280SL Mercedes?

where is the ignition relay on a 1994 280 sl


Where is the ignition module located on your 1994 dodge shadow?

The engine computer (behind the battery) is the ignition module.


Where is the ignition module on a 1994 Dodge Ram?

Passenger side of the firewall, the engine computer is the ignition module.Passenger side of the firewall, the engine computer is the ignition module.


Where is the ignition control module located on a 1994 Mercury Villager?

The ignition module and coil are contained inside the distributor and are not serviced as separate parts.


Will crank position sensor interfer with ignition module on a 1994 jeep Cherokee?

The ignition module uses the crank sensor to decide when to spark.


Where is the ignition module located on a Ford Ranger XLT 2.3l?

1994 was the last year the Ranger used an ignition control module on the 2.3 and 2.5. The ignition control module was attached to the lower intake manifold.


Why is my 1994 Ford Thunderbird not firing?

Most likely it is the Ignition Control Module.


How do you replace the ignition module on 1994 ford ranger?

To replace the ignition module on a 1994 Ford Ranger, first disconnect the battery to ensure safety. Locate the ignition module, typically mounted on the distributor or nearby, and disconnect the wiring harness. Remove the mounting screws and take out the old module, then install the new one by reversing the steps, ensuring all connections are secure. Finally, reconnect the battery and test the ignition system.


Where is the ignition control module on 1994 Ford Van E250 6 cylinder?

The only way I can explain it is to follow the wiring from your coil pack (where the spark plugs are) and the wires plug into the ignition module. Also go go www.wrenchead.ca and it has a manual that explains all. if you don't know the answer to a question please keep your moth shut ,please don't waste my time


1994 silverado turns over but wont start what is the problem?

Have you checked for fuel and spark? Fuel pumps ad burnt ignition rotors are very commen on these vehicles


1994 olds achieva wont start when hot changed the ignition module work for a couple hours and now it wont stay on help?

The new ignition module may have failed. If it is a used module its probably happened. If its a new module it still sounds like failure.