If it is the power antenna it can be accessed behind the spare tire in the left rear panel. First you must remove the antenna base nut located on the outside of the vehicle. Carefully using 2 flathead screwdrivers to turn it counterclockwise will work as the 4 notched socket made for it is a specialty tool and is not 100% necessary. If the antenna is retracted it is not necessary to remove it, otherwise it is easily removed from the housing now by prying up on the grommet with a flat head screw driver where it meets the housing. It will pull right out. Now onto the inside. Pull off the plastic covering the spare tire, then remove the tire. Position the insulation to the side. Now you can see that there is mostly sheet metal covering the pocket where the antenna and amplifier are. First you must remove the amplifier assuming there is one. There are 2 torx bit screws and a nut. Remove these and then remove the 3 electrical connectors from the base of the amplifier as well as the antenna cable. It will now slide out. Now on to the antenna. 2 nuts hold it in place. Remove them and slide it out, then remove the 1 small electrical connector from its side. You are done. Reverse to install.
"How do you replace a factory antenna on a 2002 Toyota Sienna?" I am talking about the whole assembly. Thanks
thermostat on a ford 2002
where is the speed control senor located on a 2002 ford taurus
http://www.carstereohelp.com/stereoremovalToy4Runr2PwrAnt.htm
remove it from the engine
replace coil
well you twist it off and twist the other one in its place. yep that's about it
Contact your dealer.
You cannot "fix" it. But you can replace it in about an hour.
You cannot "fix" it. But you can replace it in about an hour.
remove engine....move...replace engine
It cost me 120 for part and 120 for labor