Use a turkey baster to suck the brake fluid out of the master cylinder Replace with new fluid Bleed each wheel until new fluid runs out MAKE SURE MASTER CYLINDER DOES NOT EMPTY DURING PROCEDURE
To add brake fluid in a 1990 Mazda Protege, you need to locate the brake fluid reservoir and check the levels. The reservoir is located on the master cylinder for the brakes.
The master cylinder contains the reservoir for the brake fluid. This is where you would add it on an 1990 Cutlass Supreme.
Open the bleeder valve on the 1990 F150 wheel that needs a line replaced. When the fluid stops flowing, loosen the line connections and remove the line. Install the new line, and bleed the brake lines after the reservoir has been refilled.
the manual trans fluid runs from the brake fluid i had a 1990 Honda ef hatch an i had to fill the brake fluid an it shifted koo after that. Brake fluid operates the clutch. Do not put brake fluid into the standard transmission.
You put brake fluid in a 1990 BMD 525i in the brake fluid reservoir. This is more than likely located on the master cylinder of your braking system, under the hood of the car.
check the master cyl. if it is low on fluid that could be your problem. WARNING DO NOT ADD FLUID TO THIS ... it is whats called a (sealed system) if it is low on fluid it's a sign u need to replace barkes. u should never have to add fluid to this part of your car.
Not sure what brake pedal slip is, please try again and explain. If you are referring to brake fade then the reason is that some brake pads are more susceptible to fade that others when they get hot. You may even experience the boiling of the brake fluid. In all cases it is caused by continual high speed braking. Brake fluid contaminated with moisture makes the condition even worse. Replace all your brake fluid with clean fresh fluid from an unopened container. Brake pads have a temperture at which they become ineffective. Replace your pads with high performance pads if you are doing some high speed braking. You may also need to change rotors to a racing type rotor.
look on the brake pedal you will see a lil switch there that's the brake light switch
your brake fluid and your clutch fluid are in the same resavoir witch is just your master resavior and is located looking at the engine the right side toward the firewall
Dot 3
in the master cylander fluid resevoir,which is located under the hood on the front of the brake booster, generally on the drivers side
Yes, replace the brake booster and master cylinder.Yes, replace the brake booster and master cylinder.