Check the brake light fuse first and if good you need to replace the brake light switch that is on top of the brake pedal under the dash.
To replace the third brake light bulbs in the spoiler of a 1995 Mitsubishi Eclipse, first, remove the screws or clips securing the brake light assembly to the spoiler. Carefully pull the assembly away to access the bulbs. Twist the bulb sockets counterclockwise to remove them, then replace the old bulbs with new ones, ensuring they are securely in place. Finally, reattach the assembly and secure it with the screws or clips.
To replace the brake light on a 2001 Mitsubishi Lancer, first, open the trunk and locate the tail light assembly. Remove the screws or clips securing the assembly, then gently pull it away from the vehicle. Disconnect the electrical connector and twist the brake light bulb socket counterclockwise to remove it. Replace the old bulb with a new one, reassemble the components, and test the brake light to ensure it's working properly.
its an LED light, the whole unit has to be replaced. The spoiler needs to come off.
unscrew the light from the spoiler Disconnect the water hose Viola
is it in the rear spoiler? Thru the trunk, light socket is right below rear window
On the lancer its easy just pop the trunk open find out which lights are out and take the screws out that hold the lights in place and pop the bulb out that isn't working by turning it and replace it.
To change the brake light on a 2007 Mitsubishi Lancer GLX, first, open the trunk and locate the tail light assembly. Remove the screws or clips securing the assembly, then gently pull it out. Twist the bulb socket counterclockwise to release it, replace the old bulb with a new one, and reassemble the tail light by reversing the steps. Test the new brake light to ensure it’s working properly.
Front or back?
what you would need to do is: 1, pop the trunk and remove trunk liner 2, remove the bolts for the spoiler from the trunk lid 3, remove wiring harness connector 4, lift the spoiler off the car/trunk lid 5, remove old light fixture and install new fixture (bolt/screws) the 3rd brake light is an led, or light emitting diode, so if it burns the enitre fixture will need to be replace
To replace the brake light on a 2000 Ford Explorer, remove the screws holding the brake light in place. Gently, but firmly, pull the brake light out of the vehicle and replace with a new one.
How to replace a brake light on a nissan Tiida hatch back.