take the inside door panel off and you will see the bolts that hold the handle on, take the bolts out and unhook any linkage to the handle and pull the handle off from the outside of the door, just reverse directions to install the new handle.
Should be able to access after removing interior door panel
Yes
There is no such thing as a 2009 Monte Carlo
No
Yes
There is no such thing as a 2008 Monte Carlo
take the inside door panel off and the water paper, disconnect any rods from the handle and then there should be 2 bolts that hold the handle on, take the bolts out and the handle will come out.
no there isnt
Yes... Sort of anyway. The Monte Carlo uses a 4 door Chevelle frame even though the Monte Carlo is a 2 door car. The 4 door frame is longer than the 2 door Chevelle frame. and the wheelbase is 4 inches longer. So if you have a Monte Carlo, a 4 door Chevelle frame will work. If you have a 4 door Chevelle, a Monte Carlo frame will work. If you have a 2 door Chevelle, then you will need to use a frame from ANY 2 door GM A body except for the Monte Carlo.... The Tempest/Lemans/GTO, Cutlass, Skylark, and Chevelle all used the same frames and are completely interchangeable.
Should be in the power distribution block under the hood My fuse box on my 2000 Monte Carlo is at the end of my dash on the drivers side..To acsess the door must be open..
no, the Monte Carlo was discontinued in 2007 as the last year.
"The Chevrolet Monte Carlo, maufactured by General Motors, began production in 1970. The Monte Carlo was a two door coupe and production was stopped in 2007."