To replace the drive belt on a '96 Suburban you have to release the tention on the tentioner pulley with a wrench or socket. Once you get the belt off of at least one pulley you can release the tentioner pulley. Remove the belt the rest of the way. To re-install the belt follow the routing guide under the hood. To get the belt all the way on you'll have to release the tentioner on the pulley again to get the belt all the way on. Once the belt is all the way on release the pulley and inspect the belt to make sure it's all the way on all the pulleys. Remove the wrench or socket and you're done. Hope this helps, good luck.
The only why to repair the seat belt (retractor) is to replace the assembly,no parts are available to rebuild this assembly.
Timing Chain
The listed 1996 GMC suburban K 1500 towing capacity is 7500 pounds. Towing more than 7500 pounds will void the warranty.
very carefully
my 97 gmc suburban k2500 454 takes 7 qts of oil during oil change.
Answernot hard
It should be self adjusting, if it is slipping it could mean you need a new belt or a new belt tensioner.
It's inside the fuel tank.
5 qts with a new filter.
replace rear brake hydrolics
Get under the driver side of the suburban by the driver door and their should be a linkage that you can loosen
195 to 210 degrees is normal.