Want this question answered?
The front axles do not have a removable shaft, you must replace axles completly.
what do i have to do to replace the front drive axles on a 2004 ford ecscap???
how much to replace axles on a 2000 bravada
of what?
The first thing to check and the cheapest to fix and replace are the U joints.
There are two drive axles - one for each front wheel. These are also known as 'half-axles'.
The front axles are your "driveshafts" on ALL front wheel drive vehicles. Other wise there are no drive shafts.
Inspect the Cv boots on the axles for tears. If no tears are found then replace the wheel bearing.
Normally two.
They are both drive axles. Under normal straight ahead conditions the power is split 50/50 between the front axles.
THE INFINITY J30 IS REAR WHEEL DRIVE CAR. THE LEFT AND RIGHT REAR AXLES REQUIRE NO ADDITIONAL INFORMATION FOR PURCHASE. IS IT POSSIBLE YOU ARE REFERING TO THE I30 FROM INFINITY. IT IS NECESSARY DURING THE ORDERING OF THESE FRONT WHEEL DRIVE AXLES THAT YOU DETERMINE WHETHER THE VEHICLE IS EQUIPPED WITH LIMITED SLIP DIFFERENTIAL OR NOT. THIS INFORMATION IS AVAILABLE BY LOCATING THE INFORMATION PLATE ON THE PASSANGER SIDE OF THE ENGINE FIREWALL. THE SECOND LINE WILL REFER TO THE TRANS CODE. IF THE SEVENTH DIGIT IS A "A", IT IS WITHOUT;IF IT IS A "V" IT IS WITH LSD. KEEP IN MIND THIS ONLY MATTERS WHEN BUYING THE LEFT DRIVE AXLE.(THE RIGHT AXLE ARE THE SAME EITHER WAY)
depends on if the car is front wheel drive or rear wheel drive. If it is FWD, it will have a axle for each front wheel, if RWD, it still has 2 axles but they are housed in the cars rear end............hope this helps