answersLogoWhite

0


Best Answer

Break wheel nuts(tool: Wheel tool), jack up vehicle, Remove wheel, remove brake pads( tool: by hand or flat bit screw driver), then remove brake caliper( Tool: either 12,14,or 17 spanner or ratchet), after that you can remove the rotor by hand.

User Avatar

Wiki User

โˆ™ 2011-11-16 18:01:48
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you replace front rotors on 1996 protege?
Write your answer...
Submit
Related questions

How do you get the rotors off to replace the front brake pads and rotors on a 1996 Silverado 4wd?

1500 or 2500?? 6 lug or 8 ?


How do you replace the front rotors on a 1996 acura tl 2.5?

Those rotors are pressed on at the factory, they must be cut off and also you will need to replace the wheell bearings. Buy new rotors and wheel bearings (whole hub) approx. $84.00 each. Had mines done by acura dealership paid $ 570.00 you probably could get it done cheaper.


How do you replace the front emergency breaks on a 1996 Ford Explorer?

Actually , the 1996 Ford Explorer has small emergency brake shoes inside the back of the disc brake rotors on the REAR brakes only


How do you replace a 1996 grand prix front bumper?

How do you replace a 1996 Grand Prix front bumper?


What is thickness of brake disk on 1996 Ford Falcon?

front rotors are 25mm standard min is 22mm back rotors are 8.5mm min


How do you replace front wheel bearing on 1996 Hyundai Elantra?

how to replace front wheel bearing on 1996 Hyundai elentra


How do you replace a cigarette lighter in a 1996 Mazda Protege?

Take it out and put in a new one.......


Where is the EGR valve on a 1996 Mazda Protege?

Where is the EGR Valve on a 1996 Mazda Protege located at?


What causes front end shudder and vibration when braking on your 1996 F-350 4x4?

Warped rotors


How do you replace the rotors on a 1996 eclipse rs?

You will need to remove the tire and wheel from your Mitsubishi Eclipse. Make sure the vehicle is secure when the tire and wheel is off. Remove the brake pad assembly. Loosen the rotors with a hammer. The rotors will slide off. Reverse the process to install the new rotors.


What do yo need to replace when your 1996 Ford truck shakes when you apply the brakes only?

probably brake rotors and pads.


How do you replace your disc brake rotors on a 1996 Ford Fairlane?

Remove wheels. Remove 2 bolts securing brake caliper. Slide caliper off and support. Rotors should slide off.


What is the cause for pulsing brakes on your 1996 Plymouth Grand Voyager SE?

Warped front rotors are the most likely cause


What should it cost to replace rear brakes in 1996 Volvo 850 GLT?

What should it cost to replace rear brakes, drums and rotors, '96 Volvo 850 GLT.


How do you replace the front drivers seat on a 1996 Chevy S10 pick up truck?

How do you replace the front drivers seat on a 1996 Chevy S10 pick up truck


Do it yourself replace front brake pads and rotors 1996 ford truck?

How to Install Front Brake Pads check related link below


How do you replace front yoke on 1996 F250?

with a screw driver


DYI 1996 Mercedes E 300 front disk pad replacement?

I need to replace the front disk pads on my 1996 MB E300


How do you replace lower front ball joints 1996 jimmy?

To replace lower front ball joints in a 1996 Jimmy, raise the front of the car. Grease both ball joints and install the spindle. Next, place the spindle over the ball joints.


Po170 fuel trim malfunction bank1 1996 Mazda Protege?

po 170 fuel trim malfunction bank 1for 1996 Mazda protege


How much to fix 1996 Audi a4 breakes?

If it is the same as a 2000 A4 then you have to replace the rotors with the pads so figure $500 per axle.


How do you remove the front rotors from a 1996 Mitsubishi Galant?

Anchor and lift the vehicle. Remove tires to expose rotors and enclosing. They can be hard to remove so use a tool with force, remove center bracket then gently hammer out of place. Exchange old rotors for new. Return mechanisms and tires.


Where is the speed sensor on a Mazda protege?

i have a 1996 Mazda protege and it is at the rear of the transmission if you're looking from the front drivers side. it is almost directly under the throttle position sensor which is located on the rear of your throttle body close to the firewall (almost directly in the center of the engine compartment).


How do you replace Brakes and Rotors on a 1996 ford explorer?

Remove wheels Remove 2 caliper mounting bolts Slide caliper off rotors Rotors should slide off hub Fully retract piston into caliper body using a "C" clamp Replace inner and outer brake pads Re-Install rotors Slide caliper on rotors and re-secure REMEMBER TO PUMP BRAKES TO SET PADS AGAINST ROTORS PRIOR TO MOVING VEHICLE Remove wheels Remove 2 caliper mounting bolts Slide caliper off rotors Rotors should slide off hub Fully retract piston into caliper body using a "C" clamp Replace inner and outer brake pads Re-Install rotors Slide caliper on rotors and re-secure REMEMBER TO PUMP BRAKES TO SET PADS AGAINST ROTORS PRIOR TO MOVING VEHICLE Remove wheels Remove 2 caliper mounting bolts Slide caliper off rotors Rotors should slide off hub Fully retract piston into caliper body using a "C" clamp Replace inner and outer brake pads Re-Install rotors Slide caliper on rotors and re-secure REMEMBER TO PUMP BRAKES TO SET PADS AGAINST ROTORS PRIOR TO MOVING VEHICLE


How much does it cost to replace front brake pads and resurface front rotors on a 1996 Ford Taurus 6 cylinder?

about 150 t0 175 dollars for brake pads and new rotors at advance auto Other pricing: Autozone: * Rotors range from $26 to $45 (don't buy the 'value' rotors - more likely to warp) * Rotors that are thick enough can be turned/machined - local shop does them for only $10-15 * Pads start at $19, upgrade to $32, and top-o-the-line "CMax" ceramics (my favorite type!) at $55 Be sure to grease up the slide pins and anywhere the pads 'ride' on the caliper brackets - using BRAKE grease.