Open hood. Locate plastic housing directly behind the light (with wires entering in center). Entire housing twists a 1/4 turn to remove. This will reveals high and low beam bulbs. Low beam bulb (standard H1) is removed by unlatching wire retaining clip. Insert new bulb, clip and re-seat plastic housing.
Be sure to not touch the glass on the new bulb. The oil from your skin will cause the bulb to overheat and blow.
Your owner's manual shows how to change these bulbs on the Outback wagon and sedan. If you do not have a manual, it is available here in electronic format.
you can have the head lites adjusted correctly and/or replace the bulbs with brighter aftermarket hallogen ones.(sylvania has briter replacements available).
You have to remove the console cover. This starts with two screws in the console storage tray.
it will either be the bulbs them selves or sheck the fuses
See *Headlight* on page 10-49 of your "Owner's Manual", under Section 10: Maintenence and Service - Replacing Bulbs.....
How can I replace the headlamp on a 2000 Saturn SL1
See page 10-52 & 10-53 of your "Owner's Manual", under Section - 10: Maintenance and Service - Replacing Bulbs.....
The headlamp bulbs on a 1996 Acura TL are installed from the engine bay. Find the housing located in the front of the vehicle. Disconnect the bulbs and replace them with new units.
No. It does not.
See *Rear Combination Lights* on page 10-53 of your "Owner's Manual", under Section 10: Maintenance and Service - Replacing Bulbs.....
See *Headlight* under Maintenance and Service - Replacing Bulbs, in your "Owner's Manual" (Removing the Headlight Housing Assembly makes life a lot easier).....
Depending on the year of the vehicle depends on the light set up. If changing out the bulbs or casing there are how to video's located throughout the web.