Want this question answered?
follow the wire from the top of the distribtor cap back to it's sourcr. That's the coil. remove , replace
Disconnect the battery. Remove the ignition coils. Remove the ignition control module that was under the coils, and replace it.
If this is a 1985 with 318 V8 it is mounted on the side of the aircleaner, remove a few screws to replace it.
the cyp sensor is located inside of your distributor....you'll need to replace your distribtor
the coil is mounted to a bracket with rivets. the bracket is mounted with 2 bolts. unbolt the bracket and drill or grind the rivets out . the new coil comes with mounting screws.
These are mounted on the front of the engine....down by the fan. You'll see all the plug wires running to them. There are 3 coils....each one firing to two cylinders. The coils are mounted to the Ignition Control Module. Easiest way is to pull the cooling fan, remove the 3 bolts (1 on bottom, two on top) that hold the ICM. Unplug the wiring to the ICM and pull the entire unit out.
I would replace the ignition control module that's in the distributor.
The ignition switch is usually mounted to the steering column and is operated by a linkage rod. NOTEOn column-mounted ignition switches, don't confuse the switch with the lock cylinder and keys. The ignition switch is not normally visible. On some vehicles, the steering column support has to be removed and the column lowered to find the ignition switch. On others, the switch is accessible under the dash.The ignition switch is operated by the key switch. Courtesy of Ford Motor Company. To replace the switch: * Remove the ignition switch wiring harness. * Unbolt it from its position. * Bolt the new switch into position. * Attach the witing harness.
You can replace the ignition control module and the crankshaft position sensor as required.
You do not need a key to replace the ignition switch.
No, not if it is not defective. If the ignition switch is defective then that is all you need to replace.
The ignition switch is usually mounted to the steering column and is operated by a linkage rod.NOTE On column-mounted ignition switches, don't confuse the switch with the lock cylinder and keys. The ignition switch is not normally visible. On some vehicles, the steering column support has to be removed and the column lowered to find the ignition switch. On others, the switch is accessible under the dash.The ignition switch is operated by the key switch. Courtesy of Ford Motor Company. To replace the switch:Remove the ignition switch wiring harness.Unbolt it from its position.Bolt the new switch into position.Attach the wiring harness.