Perform this at your risk. If in doubt refer to a qualified personnel. For the instrument panel lights..first release the steering wheel adjust handle and lower the steering wheel to the bottom. now there are two screws at the top bit of the instrument panel ..remove these. then hold the bottom outer trim and gently pull it out to release clear protective plastic glass that covers the instrument panel. the top bit will come out as well.next you will see three screws on the instrument panel, two at the bottom and one at the top. remove them. Once these are out hold the instrument panel with both hands at the bottom and gently pull to unplug the the panel which is held in 2 sockets at the back. as you pull it out turn the bottom up and out from the left side of the steering wheel.be careful not to damage the circuit board!.at the back of the panel are round plastics which you can turn to release the bulbs. you only need the bigger ones which are 1 on each side and 2 at the centre top. Twist anticlockwise to remove and just pull the bulbs out. replace bulbs and reverse this procedure to put everything back.. Good luck.
take the dash out and make sure the clock is plugged in. if it is then check to see if there is power and a ground. most likely you probabily need to replace the clock.
To get to the clock you must remove the black plastic piece that is around it that surrounds the computer buttons and surrounds the instrument cluster. There are some screws around the instrument cluster, the rest snaps together.
How do you replace the clock on accord 1992
Clock
replace ford fiesta clock
A clock or watch.
clock stopwach
A clock
A clock is an instrument used to indicate, keep, and co-ordinate time.
I need to know what year the vheicle is first, but I'll give you a rough overview. The clock is lit up by a bulb in the back of the clock display in the instrument cluster. To replace the bulb you need to remove the instrument cluster (it is very easy, but I recommend the use of Mercedes Special Tools. Mercedes produces a set of hook tools especially for jobs like this.) and take out the socket and replace the bulb. Note: If you are going to remove the instrument cluster for the repair, replace all the bulbs in the cluster. Chances are if one has gone bad, others are about to go bad, so get it all done at the same time so you don't have to do it again a week later.
remove trim, remove clock, remove clock light harness, and remove and replace clock light bulbs
A clock...